Patio Festival PF19118-W 48 in. 2-Person Beige Sling Outdoor Glider Assembly Instructions

ASSEMBLY INSTRUCTIONS

STEP 1

Part # Reference Image QTY A

B

A 1

G

B 1

C

D

E

F

G

M6*15

1

1

1

1

7

Screw chair back (A) to seat board (B). M6*15 bolts (G) are used.

Please tight screws to the end.

STEP 2 C

H

G

D

H H

Screw chair armrest (C and D) to chair back (A) and seat board (B).

M6*15 bolts (G) and M6*30 (H) are used.

Please do not tighten screws to the end at this step.

STEP 3

H 6

M6*30

E

I 4 G G

M6*18

Countersunk Bolt

J 4

Place chair support beam (E) in the between of chair armrests properly and screw it. M6*15 (G) bolts are used.

Please do not tighten any screws to the end at this step.

K 1

STEP 4

Stick the hook & loop velcro of backrest and seat board.

F

J I

Finish and enjoy your chair.

Connect chair gliding base (F) to armrests with washers (J) and M6*18 countersunk bolts (I).

Make sure all bolts are connected properly, then tighten all screws to the end.

ASSEMBLY TIPS: Please use the hardware and accessories included in the set. DO NOT use other electrical or manual tools.

In order to facilitate the assembly and make your final product firm and stable, please tighten by a few rounds each screw one by one.

The assembly requires minimal level of DIY skills if you follow the instructions carefully. In case you encounter any difficulty or have any questions, feel free to contact the store or manufacturer.