THUNDER TIGER Vocans Instruction Manual

1
6
7
8
9
11
12
13
Radio Installation I
33
1. First cut two sail control lines 33.
Main Sail Control Line
Jib Sail Control Line
25”(65cm)
30”(75cm)
2. Thread the control lines through
front and rear winch line guides then
try to reach the line inside the hull.
Temporally secure the two ends on
the deck and servo tray with tape to
prevent the line loosened.
3. Refer to servo manual and install
the servo mounting hardware then
secure the servos in place. Note
the servo orientation.
4. Install the switch in place.
5. Connect the radio system
14
Radio Installation II
6
27 34 66 67 68
1. Thread the clevises 27 on the
pushrods then adjust and attach
the clevises to the servo arm when
servo and rudder are at neutral
position.
2. Thread one end of the Jib Sail
Control String to the servo drum.
Make a Figure Eight Knot in the
drum. Turn on the radio and make
sure the control stick is full down
then wind the string for two turns I
the drum then place the drum o
the winch servo.
3. Tie a Bowline Knot to the Swivel
66 on the other end of the control
zstring. Keep the string about
5/16”(8mm) out of the front winch
line guide(the length is string only
not includes the swivel ). Note: the
less turns of string in the drum the
less chance for string to be out of
the groove.
4. Do the same procedure on the
Main Sail Control String but keep
the string about 3/4”( 20mm) out of
the rear winch line guide(the
length is string only not includes
the swivel ).
5. Do the sail adjustment in page
20 after you satisfied with the
adjustment then secure the drum
with the screw comes with the
servo. Next secure the Winch
Servo Cover 67 with two Standoff
68 and 3x25mm Wood Screws 6 .
You will need to trim two notches
for the strings to go.