Water softening system. Bosch Dishwasher

en

Water softening system

To ensure good washing results, the dishwasher requires soft water, i.e. containing low amounts of lime, otherwise white limescale will be deposited on the utensils and inner container.

Tap water above 9° Clarke must be softened. The water is softened with salt

(regeneration salt) in the water softening system of the dishwasher.

The setting and therefore the required amount of salt depends on the degree of hardness of your tap water (see table).

Setting

The amount of salt dispensed can be set from

‹

to

ˆ

.

Sal is not required at the set value

‹

.

– Find out about the hardness value of your tap water. Your water utility company will help you with this.

– Set value can be found in the water hardness table.

– Close the door.

– Hold down programme button

+ and switch on the main switch

(

.

– Release both buttons.

The LED for button

+

flashes and the digital display

8

displays the factory setting

…

.

To change the setting:

– Press programme button

+

.

Each time the button is pressed, the set value increases by one level; when the value of

ˆ

has been reached, the display jumps back to

‹

(off).

– Switch off the main switch

(

The chosen setting has now been stored.

Water hardness table

:DWHU

KDUGQHVV

YDOXH

ƒ&ODUNH

+DUGQHVV

UDQJH

VRIW

VRIW

PHGLXP

PHGLXP

PHGLXP

KDUG

KDUG

KDUG

PPROO 6HWYDOXHâRQâ

WKHâPDFKLQH

´

ž

‚

±

Å

¯

³

›

6