Remaining running time display. Bosch Dishwasher

en

Remaining running time display

When the programme is selected, the remaining running time of the programme is indicated on the digital display

8

.

The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme).

Timer programming

Timer programming *

* depending on model

You can delay the start of the programme in 1 hour steps up to 19 hours.

– Switch on the main switch

(

.

– Press the timer programming button

@

until the digital display

8 jumps to

‚œ

.

– Keep pressing the timer programming button

@

until the required time is displayed.

– To delete the preselected starting time, press the button

@

until

‹œ is indicated on the digital display

8

.

You can change your programme selection at any time until the programme starts.

End of programme

The programme has ended when the value

‹ is indicated on the numerical display

8

.

Switching off the appliance

Short time after the end of the programme:

– Switch off the main switch

(

.

– Open the door.

– Turn off the tap (not applicable if Aqua-

Stop fitted).

– Remove the utensils when they have cooled down.

ã=

Warning

At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops.

Interrupting the programme

– Switch off the main switch

(

.

The LEDs go out. The programme is saved.

If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion

(pressure) may cause the appliance door to spring open or water to run out of the appliance.

– To continue the programme, switch on the main switch

(

again.

Terminating theprogramme

Terminating the programme

(Reset)

– Simultaneously press programme buttons

#

and

3 for approx. 3 sec.

– The programme sequence lasts approx. 1 min. On the digital display

8 ‹ is indicated.

– Switch off the main switch

(

.

Changing the programme

After you have switched the appliance on, it is possible to change the programme within 2 min.

If you want to change the programme afterwards, the appliance waits until the initiated programme section

(e. g. washing) ends. The remaining time comprises the remaining time of the previous programme section and the remaining time of the new selected programme.

16