Waste-water connection. Bosch Dishwasher

en

Waste-water connection

– The required work sequence can be found in the installation instructions. If required, fit a siphon with an drainage connection.

– Connect the waste-water hose to the drainage connection of the siphon with the enclosed parts.

Ensure that the drainage hose is not kinked, crushed or twisted and that there is no cover plate in the drainage to prevent the waste water from flowing out!

Fresh water connection

– Connect the fresh-water connection to the tap according to the installation instructions with the enclosed parts.

Ensure that the fresh-water connection is not kinked, crushed or twisted.

– When replacing the appliance, always use a new water supply hose.

Water pressure:

at least 0.05 MPa (0.5 bar), maximum

1 MPa (10 bar). At a higher water pressure: connect pressure-reducing valve ahead.

Inlet rate:

minimum 10 litres/minute

Water temperature:

cold water preferred; hot water max. temperature 60 °C.

Electrical connection

– Connect the appliance only to 230 V and 50 Hz alternating current via a correctly installed socket with protective conductor. See rating plate for required fusing

9*

.

– The socket must be near the appliance and freely accessible following installation.

– The connection may be modified by technicians only.

– A power cord extension may be purchased from customer service only.

– Use only a residual current operated circuit-breaker which features the symbol

‚

. Only this extension guarantees compliance with the currently valid regulations.

Removing the appliance

Also observe the sequence of worksteps here.

– Disconnect the appliance from the power supply.

– Turn off the water supply.

– Disconnect the waste water and fresh water connections.

– Loosen fastening screws for the furniture parts.

– If fitted, remove the base panel.

– Pull out the appliance, carefully pulling the hose behind.

24