Get Started . AGFEO AC 14 analog

2

Introduction

Get Started

Connect the plug at the end of the power supply into the socket labelled ”Power” until you hear it click.

Connect one end of the analogue connection cable into the socket labelled "AMT" until you hear it click in place.

Connect the other end of the cable to the socket of the network provider or the installed socket.

Connect the plugs of your telephone equipment to the telephone system.

The default setting of the AC 14 analog is that the first connection is extension 11 and the second connection is extension 12.

Plug the power supply into the 230V main socket. The red LED will flash while initialising and the light up.

Enter your phone number (see below).

You now can make calls. After lifting the telephone receiver you will hear the dial tone of the telephone exchange.

An incoming call will ring extension 11, 12, 13 and 14.

Enter your Phone Number quickly

The phone number on which you can be called can be programmed quickly and easily. With this function you can enter the phone number and at the same time allocate the phone number to the connected telephone apparatus.

Start programming mode: h

*PRO

PRO

h * 39873

(if required enter PIN, not activated by default) z # lift receiver

Programm Phone

Number

Stop programming mode: h

*END q

ª

END

Enter Phone

Number q q

ª

ª acknowledge tone replace receiver