Setting the date and time - Date model. Konica-Minolta DYNAM40, MAXXUM 50, DYNAX40M, DYNAX 30, 50, DYNAX 40

SETTING DATE AND TIME - DATE MODEL

The camera’s clock and calendar need to be set for date imprinting.

The date blinks on the data panel when the camera is turned on if the clock and calendar are not set or have reset because the batteries are exhausted.

Turn the function dial to the date select position

(SEL); the calendar is displayed on the data panel. The date format is year, month, day.

1

Turn the control dial (1) to select the date and time registers; the selected register blinks.

Calendar

To change the selected register, press and hold the function button (2) and turn the control dial (3). The camera uses a 24 hour clock so 14:00 is 2pm. The calendar is automatic from the year 2003 to 2039.

2

Clock

3

Continue until the calendar and clock are set. Turn the function dial to another position to view the standard data panel display. See page 52 on how to use the date imprinting function.

18 G

ETTING STARTED