About flash metering. Konica-Minolta DYNAM40, MAXXUM 50, DYNAX40M, DYNAX 30, 50, DYNAX 40

ABOUT FLASH METERING

The metering mode switches automatically for both the built-in and accessory flash depending on the lens in use:

ADI Flash Metering - when using D series lenses. ADI (Advanced

Distance Integration) metering uses the distance information from D series lenses in addition to Pre-flash TTL metering to control the exposure. This metering system is less influenced by background conditions or the subject’s reflectance.

Pre-flash TTL Flash Metering - when using non-D series lenses.

Pre-flash TTL (Through The Lens) flash metering system controls the flash during the exposure automatically.

This manual contains information on products and accessories available at the time of printing. To obtain compatibility information for products not contained in this manual, contact a Konica Minolta service facility.

57