About full-auto program. Konica-Minolta DYNAM40, MAXXUM 50, DYNAX40M, DYNAX 30, 50, DYNAX 40

ABOUT FULL-AUTO PROGRAM

Full-auto program completely automates the picturetaking process. When the function dial is turned to or from this position, the following are reset:

Flash mode (p. 24)

Focus area (p. 46)

Focus mode (p. 47)

Drive mode (p. 32)

Exposure mode (p. 38)

Exposure compensation (p. 42)

Exposure bracketing (p. 48)

Multiple exposure (p. 48)

Autoflash

Wide focus frame

AF

Single-frame advance

P

0.0

Off

Off

EXPOSURE WARNING - PROGRAM

When using full-auto program, subject programs, or program exposure, if the required exposure is beyond the shutter speed and aperture range, the shutter speed and aperture displays blink on the data panel. One of the viewfinder exposure indicators blink to show if the displayed exposure will cause underexposure (<) or overexposure (>).

In bright conditions, use a neutral density filter on the lens, load a slower film, or, if using artificial lights, reduce the intensity of the illumination. In dark conditions, use the built-in flash or load a faster film.

37