advertisement
Debugger
7.3
Connecting to the ICE
You must establish a communication link between the PC and the ICE. This is done by choosing the appropriate ‘port’. To make the Debugger port selection select the Project > Settings > Debugger tab.
Figure 7-2. Debugger Project Settings - LPT1
112
The “ICE connected to:” list shows parallel ports (i.e., LPT1…3) supporting the original PSoC ICE.
The definition of the USB ports are determined by this coding:
USB/yywwTxxx
Where: yy: Year the ICE was manufactured ww: Work week the ICE was manufactured
T: Type of USB connection where:
C: ICE Cube
D: USB Adapter/Dongle for a legacy ICE xxx: Manufacturing sequence number
Once you have set your debugger port, and are connected to your ICE, check the PC to ICE communication link by using the Connect button or by selecting the Debug > Connect/Disconnect
PSoC Designer IDE Guide, Document # 001-42655 Rev *B
advertisement
Related manuals
advertisement