5.1 CH INPUT jacks of this unit support the DOLBY DIGITAL
SURROPUND system.
Connect a DVD player with 5.1 CH output jacks to this unit using cables with RCA phono plugs as follows;
DVD player’s jack This unit’s jack
5.1 CH OUTPUT SUB WOOFER, etc. 5.ICH SUB WOOFER
5.1 CH OUTPUT CENTER, etc.
5.1CH OUTPUTSURROUND(L,R),etc.
5.1 CH CENTER
5.1CH SURROUND(L,R)
5.1 CH OUTPUT FRONT (L,R), etc.
5.1 CH FRONT (L,R)
LINE OUT (L, R), etc.
VI DEO/AUX
(See =,)
SURROUND SOUND
1
When a DVD player is connected to the 5.1 CH INPUT jacks of this unit, you can listen to DOLBY DIGITAL SURROUND sound, which enables you to enjoy theater-quality sound in your home.
.
1
Press VI DEO/AUX/5.l
CH repeatedly until “5.1 ch
IN” is displayed.
2 Start playing DOLBY DIGITAL SURROUND sound on the DVD player.
\ c II YPII
J
● m
If the DVD is not connected to VI DEO/AUX jack of this unit;
- the spectrum analyzer dose not show the sound level of the
DVD player.
- the sound from the connected DVD player cannot be recorded.
To remove these limitations, connect the LINE OUT jacks of the
DVD player to VIDEO/AUX jacks of this unit besides connecting to 5.1 CH INPUT jacks. The signals through VIDEO/AUX jacks enable the spectrum analyzer to work and the recording to be
● done.
Refer also to the operating Instructions of the DVD player,
DOLBY DIGITAL SURROUND sound cannot be recorded in any way.
●
The DOLBY PRO LOGIC, BBE and the SURROUND are
● automatically canceled when the 5.1 CH is selected.
Make sure the software played back with the connected DVD
● player support the DOLBY DIGITAL SURROUND.
The function is changed from the 5.1 CH to the VIDEO when;
- the headphones are plugged in.
- the MIC or ECHO level is changed.
- the Rhythm play function, the SURROUND system, the
DOLBY PRO LOGIC or the Karaoke function is turned on.
To adjust the sound levels of the center and surround speakers in DOLBY DIGITAL SURROUND
1 Press VI DEO/AUX/5.l
CH repeatedly until “5.1 ch IN” is
2 displayed.
Press MANUAL SELECT repeatedly.
Speaker names appear in turn as follows;
L/R (Speaker balance) ~ CEN: Center speaker t
S-W: Sub woofer
1
S-L: Left surround speaker
L S-R: Right surround speaker
J
3
4
Press U DOWN or UP to adjust the sound level while
“CEN”, “S-L’, “S-R or “S-W is displayed.
Each level can be adjusted between -8dB and +7dB.
Repeat steps 2 and 3 to adjust each speaker’s sound level.
If the surround speakers or the center speaker level of the DOLBY
DIGITAL SURROUND is changed, that of the SURROUND system (page 14) and the DOLBY PRO LOGIC (page 24) is also changed.
ENGLISH
31