Installation. Vizualogic A-1285, A-1286, A-1285/6, RT-043A

™

Headrest Installation

section I - Headrest Installation

1. Remove the factory headrests (Detailed instructions can be found in the vehicle’s service manual.

2. Starting with the driver’s side headrest (Monitor A) insert the mini-din connectors into the driver side headrest post guides.

3. Slowly push the cables into the seat. If an obstruction is encountered, pull back slightly on the cable and rotate before continuing. Route the cables so that they exit the bottom of the seatback.

4. Repeat steps 2 and 3 for the passenger’s side headrest (Monitor B).

section II - Wiring

1. Place the A/V Control Module in a well protected area under a seat or behind a panel.

2. Insert the Monitor's system connector cables into the A/V Control Module.

These connectors will click and lock into place when fully inserted.

3. Route the monitor and DVD cables from each headrest towards the A/V Control

Module. If additional length is necessary use the available cable extensions.

NOTE: The available extensions are not interchangeable the cable connector colors must match.

4. Connect these cables from the driver side headrest (Monitor A) to the

DRIVER MONITOR (Monitor A) the A/V Control Module.

5. Connect these cables from the passenger side headrest (Monitor B) to the

PASSENGER MONITOR (Monitor B) on the A/V Control Module.

6. Connect the wireless FM modulator antenna to the connector jack on the side of the A/V control Module labeled ANT.

7. Extend and route the FM modulator antenna under the carpet or behind a panel ensuring to avoid any sharp metal edges or moving parts. For best results do not coil or bundle the FM modulator antenna.

NOTE: If the vehicle has an aftermarket radio that accepts RCA auxiliary inputs or the use of a wireless FM modulator is not desired, simply remove the modulator antenna and connect RCAs to the Driver Monitor A/V Output (located on the side of the A/V control module) and route them to the desired component.

8. Plug the power harness into the A/V control module and connect the power wire leads to 12V+ and 12V ground. The wires are color coded as follows:

Red = ACC Power, Yellow = Constant Power, Black = Ground, Green =

Parking brake.

4

section III - system set-up/sub-menu controls

Enter the Sub-Menu, touch the “MENU” button on the screen to enter the Sub-

Menu. Use the “” and “” buttons to move up and down within the Sub-

Menu. Once the desired item has been highlighted, press the “MENU” button until the desired setting is achieved.

IR CHANNEL – This function changes the IR channel that the monitor transmits from: Ch.‘A’, Ch.‘B’ or ‘OFF’

NOTE: The driver’s side monitor is factory preset to ‘A’ and the passenger side monit or is factory preset to ‘B’. DO NOT set both monitors to the same IR channel, as this causes audible interference through the IR headphones.

SCREEN - Sets the power-up mode for the monitor when system power is turned on.

• “AUTO” - While in this mode the monitor will resume the last state it was in when the system power was last turned off.

• “ON” - When system power is turned on, the monitor will always turn on.

• “OFF” - When system power is turned on, the monitor will always remain off. The monitor must be turned on manually using the power button on the monitor or remote.

DVD MODE - Assigns the headrest identity to ensure proper source identification between Driver DVD, Passenger DVD, Ext. Aux, and Aux. via the on-screen display (OSD).

NOTE: The dual DVD headrest system’s default setting for the driver’s side is set to

‘Monitor 1’ and ‘Monitor 2’ for the passenger side. The single DVD headrest system’s default setting for the driver’s side is set to ‘DS’ and ‘PS’ for the passenger side. Do not set both screens to Monitor 1 / DS or Monitor 2 / PS. These settings must be observed in order to utilize the integrated FM modulator functions properly.

EXIT - Exits the sub-menu.

™

5