advertisement
▼
Scroll to page 2
of
34
![PREFACE. Siemens FS-250 | Manualzz PREFACE. Siemens FS-250 | Manualzz](http://s1.manualzz.com/store/data/001168350_1-84101b0edd38e65805d7b0420797f60c-360x466.png)
PREFACE
Along with the use of this instruction manual, the appropriate following standards and the manufacturer's instructions for initiating and notification devices should be used to install and maintain a functioning fire alarm signaling system.
NFPA 70 National Electrical Code
NFPA 72 National Fire Alarm Code
NFPA 101 Life Safety Code
For other standards that may apply contact the authority having jurisdiction.
In order to comply with NFPA 12A, NFPA 13 and NFPA 2001, the FS-REL releasing module must be installed.
For NFPA publications, contact:
National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269
2
advertisement
Related manuals
advertisement
Table of contents
- 7 INTRODUCTION
- 7 CONTROL PANEL LIMITATIONS
- 8 PREFACE
- 9 DESCRIPTIONS
- 9 FS-250 SYSTEM DESCRIPTION
- 9 Power Supply
- 9 P2 Addressable Device Circuit
- 10 Notification Appliance Circuits
- 10 Serial Interface Circuit
- 10 Status Relays
- 10 Programming Port
- 11 OPTIONAL MODULES
- 11 FS-MT Municipal Tie Board
- 11 FS-DACT Board
- 11 FS-NPE Transformer Assembly
- 11 FS-DLC Loop Driver Board
- 11 Battery Sets
- 11 FS-REL Releasing Module
- 12 AUXILIARY MODULES
- 12 Serial LCD Annunciator
- 12 Serial Relay Unit and Serial Relay Extender
- 12 Serial Annunciator Unit and Serial Annunciator Extender
- 12 PAD-3 Remote Signal Expander
- 13 P2 ADDRESSABLE DEVICES
- 13 FirePrintâ„¢ Smoke Detector
- 13 Heat Detectors
- 13 Addressable Modules (Monitor and Control)
- 13 Manual Stations
- 13 Programming P2 Devices
- 15 EVENT HISTORY
- 15 GENERAL DESIGN FEATURES
- 15 Environmental
- 15 Power Limiting
- 15 Ground Fault Detection
- 15 NAC Operation
- 15 Transient Protection
- 15 Security Features
- 16 REGULATORY STANDARDS
- 16 Federal Communications Commission
- 16 Underwriters Laboratories
- 17 GENERAL SPECIFICATIONS
- 17 Environmental
- 17 Primary Supply
- 17 Secondary and Trouble Power Supply
- 17 Auxiliary Power Outputs
- 17 Status Relays
- 18 Notification Appliance Circuits
- 18 Serial Interface Circuit
- 18 P2 Addressable Device Circuits
- 19 Municipal Tie (Optional Municipal Tie Board FS-MT)
- 19 DACT Circuit (Optional DACT Board FS-DACT)
- 19 Additional Transformer (Optional Transformer Sub-Assembly FS-NPE)
- 19 FS-REL (Optional Releasing Module)