advertisement
7193 Owner’s Guide Diagnostics
Setting Data Error and Data Buffer options
This function allows you to select the handling of data reception errors (RS-232C only) and to select the size of the data buffer.
Caution: The DIP switches are set at the factory to predetermined settings and should generally not be changed. If you must change the settings, do so carefully to avoid changing other functions. Run the print test to see what the current selections are for this function. See “Testing The Printer” On Page 23.
1. Turn the power off.
2. Turn the printer over and note what the current DIP switch settings are.
3. Set the switches to the settings in the table you want for data reception errors and the data buffer.
Switch 1 Switch 2 Switch 3 Switch 4 Switch 5 Switch 6 Option
On
On
On
Off
Off
Off
On
On
On
Off
Off
Off
Off
Off
On
Off
On
Off
“?” for Data Errors1, 2
Ignore Data Errors2
4K Byte Data Buffer1,
3
One Line Data Buffer On Off On Off On On
1Default
2RS-232C only
Choose one of the Data Errors options and one of the Data Buffer options.
4. Turn the power back on to enter the settings into the EEROM.
The On Line light (green) blinks.
5. Turn the power off.
6. Set the DIP switches to the former settings.
DIP switch 1 must be Off to return the printer to the on-line mode.
May 1996
advertisement
Related manuals
advertisement
Table of contents
- 9 Models
- 9 Communication Interfaces
- 9 Options
- 9 Features
- 10 Thermal Printhead
- 11 Ordering Paper and Supplies
- 11 Ordering Thermal Paper
- 13 Ordering the Power Supply and Cables
- 13 Ordering the Printer Wall-Mount Kit
- 13 Ordering Cash Drawers
- 14 Cleaning the Printer
- 16 What Is in the Box?
- 16 Removing the Packing Material
- 17 Repacking the Printer
- 18 Choosing a Location
- 19 Setting Switches
- 21 Attaching the Feet
- 22 Connecting Cash Drawer Cables
- 23 Connecting Communication and Power Cables
- 23 RS-232C Models
- 24 Parallel Models
- 25 Turning On the Printer
- 26 Loading and Changing Paper
- 26 When to Change the Paper
- 27 Removing the Paper Roll
- 28 Putting In the Paper Roll
- 29 Advancing Paper
- 28 Testing the Printer
- 30 Mounting the Printer on a Wall
- 32 Mounting the Power Supply on a Wall
- 34 Operator Panel Lights
- 35 Correcting Problems
- 35 Operator-Correctable Conditions
- 35 Service-Related Problems
- 36 Contacting a Service Representative
- 38 Level 0 Diagnostics
- 39 Level 1 Diagnostics
- 40 Setting Data Error and Data Buffer options
- 41 Setting Printhead Resistance
- 42 Setting Default Lines per Inch
- 43 Setting Partial Cut Distance
- 44 Ignoring/Using the Carriage Return
- 45 Running the Data Scope Mode
- 47 Testing Receipt Printing
- 48 Level 2 Diagnostics
- 48 Level 3 Diagnostics
- 50 Communication Overview
- 50 Interfaces
- 50 Sending Commands
- 51 RS-232C Interface
- 52 XON/XOFF Protocol
- 52 DTR/DSR Protocol
- 53 RS-232C Technical Specifications
- 57 Parallel Interface
- 57 Parallel Protocol
- 58 Parallel Technical Specifications