How to Select LOCAL/REMOTE Mode
When LOCAL/REMOTE switching function is not set for multi-function input selection
(When 17 is not set for any of constants n050 to n056)
When LOCAL/REMOTE switching function is set for multi-function input selection
(When 17 is set for any of constants n050 to n056)
Select Lo for operator
LO/RE selection.
Select rE for operator
LO/RE selection.
Turn ON multifunction input terminal.
Turn OFF multifunction input terminal.
136
LOCAL mode REMOTE mode
Selecting RUN/STOP Commands
Refer to Switching LOCAL/REMOTE Modes (page 135) to select either the LOCAL mode or REMOTE mode.
The operation method (RUN/STOP commands, FWD/REV RUN commands) can be selected using the following method.
LOCAL Mode
When Lo (local mode) is selected for Digital Operator ON mode, or when the LOCAL/REMOTE switching function is set and the input terminals are turned ON, run operation is enabled by the
on the Digital Operator, and FWD/REV is enabled by the
ON mode (using or key).
or
