advertisement
kh15816i.book Page 36 Friday, July 25, 2008 5:20 PM
KH1508i / KH1516i User Manual
Auto Scanning
Auto Scan automatically switches among all the active Computer Ports that are accessible to the currently logged on User at regular intervals, so that he can
monitor their activity automatically. (See SCAN/SKIP MODE of the OSD F3
SET function, page 26 for information regarding accessible ports).
Setting the Scan Interval
The amount of time Auto Scan dwells on each port is set with the SCAN
DURATION setting of the OSD F3 SET function (see page 26). You can
change the scan interval before activating Hotkey Auto Scanning, if you wish, with the following Hotkey combination:
1. Invoke Hotkey Mode (see page 34).
2. Key in [T] [n]
Where [T] is the letter T, and [n] is a number from 1-255 that represents the number of seconds for the dwell time.
The letter T and the numbers display on the Command Line as you key them in. If you make a mistake, use [Backspace] to erase the wrong number.
3. Press [Enter]
After you press [Enter], you automatically exit Hotkey Mode, and are ready to invoke Auto Scanning.
36
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project