Error Messages
225
Error Messages
Memory card full
No more image/movie can be saved
No image
This image cannot be displayed
No card in the camera
Memory card error
Card is not formatted
Card is locked
This image cannot be enlarged
This image is protected
Not enough battery power remaining to activate Pixel Mapping
Description
The SD Memory Card is full and no more images can be saved. Insert a new SD Memory Card or
delete unwanted images. (p.42, p.158)
You may be able to save more images if you
change the image capture settings. (p.116)
The SD Memory Card has 65,535 files saved on it and no more files can be saved. Insert a new
SD Memory Card or delete unwanted files. (p.42, p.158)
There are no images that can be played back on the SD Memory Card.
You are trying to play back an image in a format not supported by this camera. You may be able to play it back on another brand of camera or a computer.
There is no SD Memory Card inserted in the
camera. (p.42)
The SD Memory Card has a problem, and image capture and playback are impossible. It may be viewable on a computer but not with this camera.
The SD Memory Card you have inserted is unformatted or has been formatted on another device and is not compatible with this camera.
Use the card after formatting it with this camera.
(p.193)
The write-protect switch on the SD Memory Card you have inserted is locked. Unlock the SD
Memory Card.
You are trying to enlarge an image that cannot be enlarged.
You are trying to delete an image that is protected. Remove protection from the image.
(p.194)
Appears during Pixel Mapping if the battery level is insufficient. Install a fully charged battery, or
use the AC adapter kit (optional). (p.40)
11
226
11
Error Messages
Not enough battery power remaining to update the firmware
Unable to update firmware.
There is a problem with the firmware update file
Image folder cannot be created
Unable to store image
Settings not stored
The operation could not be completed correctly
No more images can be selected
No image can be processed
This image cannot be processed
The camera failed to create an image
This function is not available in the current mode
The camera will turn off to prevent damage from overheating
Description
Appears when trying to update the firmware if the battery level is insufficient. Install a fully charged battery, or use the AC adapter kit (optional).
(p.40)
Unable to update the firmware. The update file is damaged. Try downloading the update file again.
(p.191)
The maximum folder number (999) and file number (9999) are being used, and no more images can be saved. Insert a new SD Memory
Card or format the card. (p.193)
The image could not be saved because of an SD
Memory Card error.
The DPOF settings could not be saved because
SD Memory Card is full. Delete unwanted images
and perform DPOF setting again. (p.158)
The camera was unable to measure the manual
white balance (p.122) or use HDR Capture
(p.125). Try the operation again.
You cannot select more than the maximum
number of images for Index (p.153) and Select &
Delete (p.158).
There are no images that can be processed
using Digital Filter (p.168) or RAW Development
(p.174) function.
Appears when you try to perform Resize (p.166),
Cropping (p.167), Digital Filter (p.168), Red-eye
Edit (p.173) or RAW Development (p.174) for
images captured with other cameras, or when you try to perform Resize or Cropping for minimum file size images.
The creation of an index print image failed.
(p.153)
You are trying to set a function that is not available when the capture mode is set to n
(Auto Picture), H (Scene) or C (Movie) mode.
The camera will turn off because its internal temperature gets too hot. Leave the camera turned off until it has had time to cool down before turning on the camera again.
