Appendix

Print Using LPR

The purpose of this appendix is to help you submit the various test patterns necessary to perform the pre-calibration and color calibration procedures found in this guide to the printer.

The following procedure uses LPR (Line Printer Remote) to submit a job to the printer.

1.

Select [Start] and [Run].

2.

Type [cmd] and select [OK].

B

3.

A command-prompt window will appear. Type the following exactly as shown, substituting the IP Address of the printer for [printer IP address], the and any underscores for spaces; do not type the underscores unless it is actually part of the queue name: [lpr_-S_[printer IP

address]_-P_[queue name] _ ].

4.

Ensure that the command-prompt window is small enough so that you can see the

Windows Explorer window behind it that has the [Color Calibration Resources] directory open.

5.

Select the appropriate test pattern to be printed and hold down the left mouse button.

Printer Operator Guide B-1

Appendix Xerox 490/980 Color Continuous Feed Printing System

6.

Drag and drop the .pdf into the command-prompt window. The location of the .pdf will automatically be entered into the command-prompt window in double-quotes.

Drag and drop the test pattern

7.

Ensure that the command prompt window is selected. Enter one space after the last double-quotes of the filename.

8.

Go back to the original procedure that referenced this appendix. Compare what you have typed into the command prompt window to the text in the graphic before submitting the job to the printer.

B-2 Printer Operator Guide

©2008 by Xerox Corporation. All rights reserved. Xerox® and the sphere of connectivity design and

490/980

TM

are trademarks of Xerox Corporation in the United States and/or other countries.