Attaching a Lens
Attach a proper lens to the camera’s body.
When you use one of the following lenses with the X, all the camera’s exposure modes will be available.
(a) DA, DA L, D FA, FA J lenses an (Auto) position, when used in the s position
2
Turn the camera off before attaching or removing the lens to prevent unexpected lens movement.
• When lenses described in (b) are used in a position other than s, some
functions will be restricted. Refer to “Notes on [27. Using Aperture Ring]”
(p.339).
• With factory default setting, the camera will not work with lenses other than
those listed above and accessories. Set [27. Using Aperture Ring] to
[Permitted] in the [A Custom Setting 4] menu to use them. (p.339)
1
Make sure the camera is turned off.
2
Remove the body mount cover
(1) and lens mount cover (2).
Be sure to put the lens down with the lens mount side facing upward to protect the lens mount from damage.
3
Align the Lens mount index (red
dots; 3) on the camera and the lens, and secure by turning the lens clockwise until it clicks.
After attaching, turn the lens counterclockwise to check that the lens is locked in place.
3
59
60
4
Remove the front lens cap by pushing the indicated portions inward.
2
To detach the lens, hold down the lens unlock button (4) and turn the lens counterclockwise.
4
• We assume no responsibility nor liability for accidents, damages and malfunctions resulting from the use of lenses made by other manufacturers.
• The camera body and lens mount incorporate lens information contacts and an AF coupler. Dirt, dust, or corrosion may damage the electrical system.
When necessary, clean the contacts with a soft dry cloth.
The body mount cover (1) is a cover to prevent scratches and block dust when shipped. Body Mount Cap K is sold separately and has a lock function.
