Loading - External Media. Datamax Mark III E-4206L, E-4206L, Mark III E-4305L, Mark III E-4206P, E-4305A, E-Class Mark III Professional+, E-4206P, E-Class Mark III, Mark III E-4305P

Loading - External Media

Using Internal Media Chute Guides Accessory (Professional model only)

Load media as follows:

1) Slide the Media Guides outward.

2) Slide the Media Hangers outward and install the two Media Chute Guides into the Media Hangers.

 Media Chute Guides

 Media Hangers

 External Media Guide

3) Position the Media Hangers to match the width of the media being used. Slide the Hanger Lock against the Media Hanger to hold this position.

 Media Hangers

 Hanger Lock

Chapter 2 – Printer Setup 11

4) Route the media through the External Media Slot in the rear of the printer. Pull out enough media to exit the front of the printer. Adjust the Media Guides so they are lightly touching the edge of the media.

 External Media Slot

 Media Guides

 External Media Supply

5) If using Thermal Transfer media (ribbon) proceed to Section 2.4 Loading Ribbon. Otherwise close the printer’s Cover and press downward until latched.

6) Press the button to advance the media (if the Fault Light is lit, see Section 3.7.)

 The printer is factory set to use gap media. If using another media type (for example, continuous media), printer setup must be reconfigured; see Section 3.4

.

12 Chapter 2 – Printer Setup