Safety precautions. Haier HWM130-0713S

Add to My manuals
18 Pages

advertisement

Safety precautions. Haier HWM130-0713S | Manualzz

Safety precautions

Please insert the power cord into special receptacle with rated voltage. Be sure to use single-phase

three pins receptacle. The earthing

terminal of the receptacle must be

earthed reliably. If possible, please adopt electric leakage protector.

When the machine is normally using, please put the power plug at the location easily to be inserted and extracted by hand. Be sure to pull the plug off when there's power failure, or the machine is being moved, cleaned or when it is idle.

If the power cord is bad, to avoid risk it is required to replace it by the technicians of our special shop or the after-sale service department.

Keep the pin of the power plug clean.

Do not put the machine at damp place like the bathroom . Never wash it with water. Do not place wet laundries on the control panel.

Do not use water hotter than 50 C .

In case the washing machine is installed on ground with carpet , do not block the ventilation hole with carpet.

Ventilation hole at the bottom of the washing machine

Do not wash water-proof laundries like the raincoat, bike covers etc. to avoid abnormal vibrations in spinning.

Do not let the machine share one receptacle with other electric appliances. If the power plug is damaged, or the plugging into the receptacle is loose, do not use the plug any more.

2

Safety precautions

Do not stretch hands into the working machine. It is dangerous even if the rotation is slow. Take special care of the children.

Do not decompose, repair or alter the machine by yourself.

Do not put any hot or heavy items

( such as the kettle with hot water ) on the washing machine.

Do not wash laundries with volatile materials (such as thinner, petrol etc.).

Petrol

Thinner

Handicapped or children without care shall not use the machine.

Keep the machine away from direct sunlight and heat source like the

heater.

Please put down the drain hose before washing and connect the water inlet pipe properly.

It is suggested to use foamless washing powder.

Please don t use the washer in the environment below 0 C. If the washer is below 0 C, the washer s water inlet system and draining system will be frozen ,then result in the damaged of the whole machine. If the washer has below 0 C, please be sure to ensure the washer is placed under the room temperature for 2~4 hours and then use .

3

advertisement

Related manuals