6 Setting Up NT Graphics Console Redirection Using pcANYWHERE. HP TopTools Remote Control, D6028-90004

6 Setting Up NT Graphics Console

Redirection Using pcANYWHERE32

For NetServer systems running Microsoft Windows NT 3.51 or 4.0, you can redirect the server’s NT graphics console to a remote PC client to remotely perform operations as if you were sitting at the server. To do this, you must install pcANYWHERE32 software. pcANYWHERE32 components must be installed and configured at both the server and the remote client to use NT remote control. The figure below show how it works:

At the Remote Client Using

a Modem: the user dials into

HP TopTools Remote

Control, selects "NT Remote

Control," hangs up and dials back to the server using pcANYWHERE32 and takes full graphics control of the

HP NetServer.

Remote

Console

At the Remote Client Using

the LAN: the user launches pcANYWHERE32 and takes full graphics control of the

HP NetServer.

Modem LAN Modem

At the Server: after installing pcANYWHERE32 and configuring it for LAN and/or modem communications, the server may be taken over by the remote client via a

LAN and/or modem connection.

NetServer

LAN

Figure 6-1. NT Console Redirection to a Remote Client

41