advertisement
5 Connecting to power supply
Electronics compartment
5.6 Wiring plan, double chamber housing Ex d ia
2
4...20mA
Terminal compartment
+ 1 2 (-)
1
5 6 7 8
3
Fig. 31: Electronics compartment, double chamber housing Ex d ia
1 Internal connection to the connection compartment
2 For display and adjustment module or interface adapter
3 Internal connection to the plug connector for external display and adjustment unit (optional)
Note:
HART multidrop mode is not possible when using an Ex-d-ia instrument.
4...20mA
Plug M12 x 1 for external display and adjustment unit
+ 1 2 (-)
1
Fig. 32: Terminal compartment, double chamber housing Ex d ia
1 Voltage supply, signal output
2 Ground terminal for connection of the cable screen
4 3
2 1
Fig. 33: Top view of the plug connector
1 Pin 1
2 Pin 2
3 Pin 3
4 Pin 4
VEGAPULS 69 • 4 … 20 mA/HART two-wire
2
33
advertisement
Related manuals
advertisement
Table of contents
- 4 1.1 Function
- 4 1.2 Target group
- 4 1.3 Symbols used
- 5 2.1 Authorised personnel
- 5 2.2 Appropriate use
- 5 2.3 Warning about incorrect use
- 5 2.4 General safety instructions
- 6 2.5 CE conformity
- 6 2.6 NAMUR recommendations
- 6 2.7 Radio license for Europe
- 7 2.8 Environmental instructions
- 8 3.1 Configuration
- 9 3.2 Principle of operation
- 10 3.3 Packaging, transport and storage
- 10 3.4 Accessories and replacement parts
- 13 4.1 General instructions
- 13 4.2 Mounting versions, plastic horn antenna
- 16 4.3 Mounting preparations, mounting strap
- 16 4.4 Mounting instructions
- 27 5.1 Preparing the connection
- 27 5.2 Connecting
- 29 5.3 Wiring plan, single chamber housing
- 30 5.4 Wiring plan, double chamber housing
- 32 5.5 Double chamber housing Ex d
- 33 5.6 Wiring plan, double chamber housing Ex d ia
- 34 5.7 Double chamber housing with DIS-ADAPT
- 35 5.8 Wiring plan - version IP 66/IP 68, 1 bar
- 35 5.9 Switch-on phase
- 36 6.1 Insert display and adjustment module
- 37 6.2 Adjustment system
- 38 6.3 Measured value indication - Selection national language
- 39 6.4 Parameter adjustment - Quick setup
- 40 6.5 Parameter adjustment - Extended adjustment
- 54 6.6 Saving the parameter adjustment data
- 56 7.1 Connect the PC
- 57 7.2 Parameter adjustment
- 58 7.3 Saving the parameter adjustment data