Operating Instructions VEGAPULS 69

6 Set up with the display and adjustment module

6 Set up with the display and adjustment module

6.1 Insert display and adjustment module

The display and adjustment module can be inserted into the sensor and removed again at any time. You can choose any one of four different positions - each displaced by 90°. It is not necessary to interrupt the power supply.

Proceed as follows:

1. Unscrew the housing cover

2. Place the display and adjustment module in the requested position onto the electronics and turn to the right until it snaps in

3. Screw housing cover with inspection window tightly back on

Disassembly is carried out in reverse order.

The display and adjustment module is powered by the sensor, an additional connection is not necessary.

36

Fig. 37: Installing the display and adjustment module in the electronics compartment of the single chamber housing

VEGAPULS 69 • 4 … 20 mA/HART two-wire