MT 3350

• press the key to display the total number of spins performed by the machine since its first start-up (tot SPi)

• press the key to display the number of spins performed since the last sensitivity calibration (CAL SPi). It is reset at each new calibration.

• press the key to display the number of spins performed since the last sensitivity calibration (PAr SPi). It is reset each time it is turned off.

• press the key to exit.

15. GENERAL CONFIGURATIONS - SET UP

The machine can be configured according to your requirements. The following configurations are available:

- Selecting vehicle type (car – motorcycle)

- Selecting the mode for acquiring wheel dimensions in the ALU1 and ALU2 balancing programmes

- Unbalance unit of measurement

- Unbalance rounding-off

- Warning OPT

- Rim diameter display unit of measurement

- Rim width display unit of measurement

- Acoustic signal

- Setting - Adhesive weight application position (h3-h6-h12)

- LED light (if provided)

- Laser indicator (if provided)

Proceed as follows to access the configuration menu: key • press the

• use the keys to search for SEt UP

• Press the key.

Operator's manual MT 3350 111

15.1. SET UP - SELECTING VEHICLE TYPE

(CAR-MOTORCYCLE)

Configuration used for enabling motorcycle wheel balancing functions.

Proceed as follows to recall this programme:

- Press the

- use the

- press the

- use the

- press the

CAr on

- press the key.

keys to search for SEt UP

key to confirm

keys to search for CAr on (or CAr oFF if previously set)

key to change the setting: to activate the car working environment to activate the motorcycle working environment

key to confirm and exit.

Warning

Proceed as follows to balance a motorcycle wheel:

- fit the motorcycle wheel adapter A (AUMO) on the wheel balancer as shown in Fig. 21;

- insert the two screws that are supplied in the holes on the wheel contact flange;

- tighten the screws on the adapter making sure that it rests on the flange correctly;

- fit the most suitable pin (depending on the wheel central hole) onto the shaft after removing the threaded hub;

- mount the wheel after selecting the centring cones (one for each side of the wheel), tighten with the appropriate ring nut using the spacers necessary for coupling the securing cones to the threaded part of the shaft.

- mount the relative extension (A, Fig.22) on the internal measuring arm.

- set the wheel data as shown in the paragraph "Entering wheel dimensions".

112 Operator's manual MT 3350