Maintenance and cleaning. Parkside PKZ 180 B2

GB using the adapter nozzle

Area of use:

You can insert the adapter nozzle in a vent valve. You will fi nd this together with other valves

(standard valve, screw valve, ...) on large-volume items, for example an infl atable mattress.

♦ Press the lever quick coupler downwards to attach it.

♦ Insert the nozzle adapter into the lever quick coupler and then release it.

♦ Screw the nozzle adapter into the adapter nozzle .

♦ Infl ate as described above.

Maintenance and cleaning

WARNING! RISK OF INJURY! Switch the appliance off and remove the power plug before commencing any work to the appliance.

■ Do not use any sharp objects to clean the appliance. Never permit fl uids to penetrate inside the appliance. The appliance could be damaged. The carbon brushes should only be replaced by the service centre or an authorised specialist workshop. Apart from this, the appliance is maintenance-free.

■ Ensure that the appliance has cooled down completely, otherwise there is a risk of burns.

■ The appliance must be depressurised before all cleaning and maintenance tasks. To do this, open the release valve until no more air escapes.

■ Clean the appliance regularly, preferably immediately after completion of the work.

■ Clean the housing with a dry cloth – do NOT use petrol, solvents or cleaners that can attack the plastic.

■ Ensure that no water gets into the appliance.

■ Ventilation openings must never be obstructed.

NOTE

► Replacement parts not listed (such as carbon brushes, switch) can be ordered via our service hotline.

NOTE

This appliance is maintenance free. Never open the appliance. The appliance may only be repaired by an authorised service centre or Customer Service. If one of the faults listed below occurs, note the following:

♦ Disconnect the appliance from any power supply.

♦ Allow the appliance to cool down and wait a short while for the residual energy to neutralise.

♦ Ensure that the appliance is in good working condition.

Troubleshooting

Fault Solution

1. Appliance does not run

1. Check your power supply.

Check that all cables, fuses and the mains socket are in working order.

2. Do not use excessively long extension cables.

3. Do not use the appliance at temperatures below

+5 degrees.

4. Avoid overheating the motor. Allow the motor to cool down.

2. Working pressure too low

3. Tools do not work

Check the seals and the nonreturn valve. Replace these if necessary.

Check the hoses, quick coupler and the tools. Replace these if necessary.

32

PKZ 180 B2