Inserting the Batteries
Insert batteries into the camera. Use four AA lithium batteries, AA Ni-MH batteries, or AA alkaline batteries.
This camera is packaged with AA lithium batteries for checking the camera functionality but some other kinds of batteries are also compatible. Use the compatible batteries according to the intended purpose.
2
AA lithium batteries Provided with the camera. Recommended in cold climates.
AA Ni-MH rechargeable batteries
AA alkaline batteries
These are rechargeable and are economical.
A commercially available battery charger that is compatible with the batteries is required.
These are easily obtainable when your usual batteries run out but they may not support all the camera functions under certain conditions. We do not recommend their use except in emergencies and checking the camera functionality.
• The use of Ni-Mn batteries is not recommended as the batteries’ voltage characteristics may cause a malfunction.
• AA lithium batteries and AA alkaline batteries that can be used in this camera are not rechargeable.
• Do not open the battery cover or remove the batteries while the power is on.
• Remove the batteries when you will not use the camera for a long while. The batteries may leak.
• If the date and time settings have been reset when you insert new batteries
after a long time, follow the procedure for “Setting the Date and Time” (p.52).
• Insert batteries correctly. Batteries inserted incorrectly may cause a camera breakdown. Wipe the electrodes of the batteries before inserting.
• Replace all the batteries at the same time and do not mix battery types, brands or old batteries with new ones. Otherwise, malfunctions, such as the battery level not being displayed properly, may occur.
1
Push and hold the battery cover unlock lever as shown in
the illustration (1), and slide the battery cover toward the
lens (2), and then flip open.
1
2
37
38
2
Insert the batteries according to the +/– indicators in the battery chamber.
2
3
Press down on the batteries
with the battery cover (1) and slide it as shown in the
illustration (2) to close.
1
2
Be sure to fully close the battery cover. The camera will not turn on if the battery cover is open.
• Use the AC adapter D-AC76 (optional) when using the camera for a
prolonged period. (p.40)
• Check the battery orientation if the camera does not operate properly after replacing the batteries.
Battery Level Indicator
You can confirm remaining battery level by checking the { displayed on the LCD panel.
: Battery is full.
{ lit
¶
} lit
¶
?
lit
¶
?
blink
: Battery is running low.
: Battery is almost empty.
: The camera turns off after displaying a message.
• } may appear even when the battery level is sufficient if the camera is used at low temperatures or when performing continuous shooting consecutively. Turn the camera off and on again. If { appears, you can use the camera.
• { does not appear on the LCD panel when using the AC adapter D-AC76
(optional).
39
Approximate Image Storage Capacity and
Playback Time (new batteries)
Batteries
AA lithium batteries
AA rechargeable batteries
(NiMH 2500mAh)
(Temperature)
Normal recording
(23°C) 1100
( 0°C)
(23°C)
( 0°C)
900
700
500
Flash photography
50% use 100% use
550
440
400
280
350
250
240
190
Playback time
700 minutes
600 minutes
480 minutes
400 minutes
AA Alkaline batteries
(23°C)
( 0°C)
200
Not applicable
80
Not applicable
50
Not applicable
300 minutes
200 minutes
The picture storage capacity (normal recording and flash use 50%) is based on measuring conditions in accordance with CIPA standards and the others are based on PENTAX measuring conditions. Some deviation from the above figures may occur in actual use depending on shooting mode and shooting conditions.
• Battery performance temporarily decreases as the temperature decreases.
When using the camera in cold climates, have extra batteries on hand and keep them warm in your pocket. Battery performance will return to normal when returned to room temperature.
• Have extra batteries ready when traveling overseas, taking pictures in cold climates, or when you will be taking a lot of pictures.
2
40
Using the AC Adapter (Optional)
4
2
2
1
3
We recommend using the AC adapter D-AC76 (optional) when using the monitor for a long time or when connecting to your PC.
1
Make sure the camera is turned off before opening the terminal cover.
2
Connect the DC terminal on the AC adapter to the DC input terminal on the camera.
3
Connect the AC plug cord to the AC adapter.
4
Plug the AC cord into the power outlet.
• Make sure the camera is turned off before connecting or disconnecting the
AC adapter.
• Make sure connections are secure between the camera, AC adapter, AC plug cord terminal and the power outlet. SD Memory Card and data will be corrupted if disconnected while camera is recording or reading data.
• Be sure to read the AC adapter D-AC76 Operating Manual when using the
AC adapter.
• The rechargeable batteries in your camera will not charge when connected to the AC adapter.
