128
Compensating Flash Output
You can change the flash output in a range of –2.0 to +1.0. The flash compensation values are as follows for 1/2 EV and 1/3 EV.
Step interval
1/2 EV
1/3 EV
Flash compensation
–2.0, –1.5, –1.0, –0.5, 0.0, +0.5, +1.0
–2.0, –1.7, –1.3, –1.0, –0.7, –0.3, 0.0, +0.3, +0.7, +1.0
* Set interval of steps in [1. EV Steps] (p.101) in the [A Custom Setting] menu.
Set the flash compensation value by turning the e-dial in the [Flash Mode]
screen in the Fn menu (p.77).
5
OK
• If the maximum flash output is exceeded when corrected to the plus (+) side, no compensation will be effective.
• Compensating to the minus (–) side may not effect the image if the subject is too close, aperture is low or sensitivity is high.
• This flash compensation is also effective for external flash units which support P-TTL auto flash mode.
• Pressing the Green button on the [Flash Mode] screen resets the flash exposure compensation to the default setting [0.0].
