5 - 10 Workabout Pro4 (Windows Embedded Hand-Held 6.5) User Manual
• Four Slot Battery Charger – can consume up to 2A @ 120VAC or 1A @ 240VAC.
• Four Bay Ethernet Cradle – can consume up to 3A @ 120VAC or 1.5A @ 240VAC.
Operator Controls
Workabout Pro4 cradles and chargers have no operator controls or power switches.
Important Charger Safety Instructions
• SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for battery chargers.
• Before using the battery charger, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery.
• The mains power cord shall comply with national safety regulations of the country where the equipment is to be sold.
• Use of an attachment not recommended or sold by the battery charger manufacturer may result in fire, electric shock, or personal injury.
• To reduce risk of damage to the electric plug and cord when unplugging the charger, pull the plug rather than the cord.
• Make sure the cord is positioned so that it is not stepped on, tripped over, or otherwise subjected to damage or stress.
• Do not operate the charger with a damaged cord or plug. Replace immediately.
• Do not operate the charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; it should be inspected by qualified service personnel.
• Do not disassemble the charger; it should be repaired by qualified service personnel. Incorrect reassembly may result in electric shock or fire.
• To reduce risk of electric shock, unplug the charger from the outlet before attempting any maintenance or cleaning.
• An extension cord should not be used unless absolutely necessary. Use of an improper extension cord could result in fire or electric shock. If an extension cord must be used, make sure:
- The plug pins on the extension cord are the same number, size and shape as those on the charger.
- The extension cord is properly wired and in good electrical condition and that the wire size is larger than
16 AWG.
• Do not expose the charger to rain or snow.
• Do not place batteries in the charger if they are cold from extended exposure to a freezer or outside temperatures below 10°C (50°F). Allow them to warm up to room temperature for at least two hours.
• Do not use the charger if, after an overnight charge, any of the batteries feel warmer than the charger housing. The charger should be inspected by qualified service personnel.
• Do not use the charger if any of the batteries or the charger get more than lukewarm. The equipment should be inspected by qualified personnel.
Single Bay USB Cradle
The Workabout Pro4 can be inserted in a Single Bay USB Cradle, model number WA4003-G2.
Peripheral Devices & Accessories 5 - 11
Figure 5-4 Single Bay USB Cradle
Workabout Pro4
Charge Well
Release Button
Connector
Pins
LED
(Indicates charge status of a spare battery inserted in the rear charge well of the single bay USB cradle.)
NOTE The single bay USB cradle is shipped with its own user manual. It is critical that it be reviewed for additional information and updates.
Figure 5-5 Back Of Single Bay USB Cradle
Spare Battery
Spare Battery
Charge Well
Client USB Port
Host USB Port
DC IN Socket
IMPORTANT This single bay USB cradle can only be used to charge Zebra approved Lithium-Ion batteries.
