Copying a Frequency into a Specified Channel. Radio Shack PRO-96, PRO-2096

Copying a Frequency into a Specified Channel

You can copy a frequency into a specified channel when the scanner stops on that frequency during search mode or manual tuning. If a CTCSS or DCS code is detected on the transmission, the detected code will be copied into the channel memory as well.

1. Press FUNC then PGM when you find a frequency.

Chan Store?

appears on the bottom line. After about 1 second, the frequency to be copied flashes on the indicator.

2. Press the desired bank and the channel number where you want to store the frequency. The display indicates the bank and channel number, and briefly displays the frequency that is currently programmed into the selected channel. You can repeat this step as needed until you find an acceptable destination channel. After about 1 second, the frequency to be copied flashes.

3. Press ENTER. All the conditions such as receive mode and delay condition are copied onto the channel.

Chan Store!

briefly appears in the scanner’s display. The scanner automatically returns to search mode.

Note

•

If you try to copy a frequency that is already stored, the scanner sounds the notice tone 3 times after you press ENTER.

Dupl.f Chxxx

appears at the bottom line. If you want to copy the duplicate frequency anyway, press ENTER, or if not, press CLR to cancel.

Copying a Frequency into a Vacant Channel in a Specified Bank

You can copy a frequency into a vacant channel in a specified bank when the scanner stops on the frequency during search or tune mode.

1. Press FUNC then ENTER when you find a frequency you want to copy.

Bank9

Store?

appears in the scanner’s display.

2. If you want to copy the frequency into bank 9, press ENTER. It is stored in the first available vacant channel in the bank. Or, press your desired bank number to store, then press ENTER to store the frequency in the selected bank.

Chan Store!

appears for 2 seconds. All the conditions such as receiving mode and delay

61