Clearing a Locked-Out Search Frequency. Radio Shack PRO-96, PRO-2096

Clearing a Locked-Out Search Frequency

To clear a locked-out frequency, select that frequency (see “Reviewing Locked-Out

Search Frequencies” on Page 66), then press CLR.

If all locked-out frequencies are cleared within a channel storage bank,

Empty.

Lockout list

appears in the scanner’s display.

Clearing All Locked-Out Frequencies in a Search Bank

1. Press SEARCH.

2. Select the search bank in which you want to clear all locked-out frequencies.

3. Press FUNC then press L/OUT. Lockout list appears in the scanner’s display.

4. Press FUNC then 6. The scanner will display

Confirm list clear? 1=Yes Press other key for NO

. Press 1 to clear all locked-out frequencies.

List cleared appears for about 2 seconds. Press any key other than 1 to cancel clear.

Changing the Receive mode

The scanner defaults to the commonly used AM or FM/Digital receive mode for each frequency range. The preset mode is correct in most cases. However, some amateur radio transmissions and trunked systems do not operate in the preset mode. If you try to listen to a transmission when the scanner is not set to the correct receive mode, the transmission might sound weak or distorted.

To change the receive mode, repeatedly press MODE. The receive mode changes as follows:

AM

– configures the channel for AM mode

FM/DIGITAL

– configures the channel for the FM/DIGITAL mode

CT

– configures the channel for CTCSS mode

DC

– configures the channel for DCS mode

MO

– configures the channel for the MO mode for analog or digital Motorola trunking system channels, or APCO-25 trunking system channels

67