Enabling/Disabling the operation sound
[GENERAL] - [SOUND SETTING] -
[AUDIBLE TOUCH TONE]
You can make this station sound a beep whenever the touchscreen is touched.
1 From HOME window, touch SETTINGS →
GENERAL → SOUND SETTING .
2 Touch AUDIBLE TOUCH TONE and select
“ENABLE” or “DISABLE”.
3 Touch ENTER to save change.
Adjusting brightness and volume
[ADJUST]
You can adjust the brightness of the screen and sound volumes.
1 From HOME window, touch SETTINGS → ADJUST .
The setting window appears.
Enabling/Disabling door release
[GENERAL] - [DOOR RELEASE]
You can make it possible (ENABLE) or not (DISABLE) to release door locks from this station.
Set for Door 1 to Door 4 individually.
If "DOOR1" is set to "ENABLE", when receiving a call from a door station or while monitoring an entrance, 1 and
2 are displayed on the screen. Touching 1 activates the door release device for Door 1.
If it is set to "DISABLE", 1 and 2 are grayed out and disabled.
1 From HOME window, touch SETTINGS →
GENERAL → DOOR RELEASE .
2 Enter the 4-digit PIN by using the touchscreen, then touch ENTER .
“DOOR1” to “DOOR4” are displayed.
* If a wrong PIN has been entered, an error message is displayed. Enter correct PIN. (See page 15 for PIN settings).
3 To change the setting for “DOOR1”, select “ENABLE” or “DISABLE”.
4 Repeat for other door stations.
5 When the setting has fi nished, touch ENTER .
..........Adjusts brightness of the screen.
.........Adjusts the speaker volume when talking in hands-free mode.
..........Adjusts the output volume when talking with handset.
...........Adjusts the volume of call tone from door station(s).
.........Adjusts the volume of call tone from other residential station(s).
(for calling both a single station and all stations)
Volume adjustment range: 0 (mute), 1 - 10
2 Touch or to adjust the levels.
3 Touch ENTER to save change.
17