advertisement
▼
Scroll to page 2
of
24
September 2015
Note: It is OK for the ‘UBOOT Version’ to display “n/a”. The ‘UBOOT-miniboot’ version should be the upgraded version as shown above.
Remove the CPLD and Uboot/Miniboot Upgrade Files
After the switch/stack has been upgraded and verified the upgrade files can be removed from the switch.
1. Issue the following command to remove the upgrade files.
-> rm KFfpga.upgrade_kit
-> rm kfu-boot.bin
-> rm kfminiboot.bs
Page 22 of 24 OmniSwitch 6250/6350/6450 —Release 6.7.1.R01
advertisement
Related manuals
advertisement
Table of contents
- 4 Memory Requirements
- 4 Miniboot and FPGA Requirements for Existing Hardware
- 6 New OmniSwitch 6350 Switches
- 6 OS6350-24
- 6 OS6350-P24
- 6 OS6350-48
- 6 OS6350-P48
- 6 Transceivers
- 8 Chassis / System
- 8 Monitor Interswitch Stacking Connections
- 8 Layer 2
- 8 Prioritization of ERP Packets
- 8 Layer 3
- 8 IPv6 Supported RFCs / IPv6 Phase 2 Logo
- 8 IPv6 Security - Source Guard
- 8 IPv6 Source Filtering is an IPv6 security feature. When IPv6 source guard is enabled on an interface, all unknown IPv6 traffic coming in on the interface is sent to the CPU. The software looks up the IPv6 source address to source MAC address in a bind...
- 8 IPv6 source filtering applies to DHCPv6 Snooping ports, link aggregates, and VLANs and restricts port traffic to only packets that contain the client source MAC address, IPv6 address, and VLAN combination. The DHCPv6 Snooping binding table is used to ...
- 8 IPv6 Security – Router Advertisement (RA) Guard
- 9 IPv6 DHCP Relay/snooping/circuit-id
- 9 Management
- 9 RCL- DHCP Server Priority
- 10 Metro
- 10 CPE Test Head enhancements
- 10 Security
- 13 QoS
- 13 System
- 14 CMM (Primary Stack Module) and Power Redundancy Feature Exceptions
- 14 Stack Element Insert/Removal Exceptions
- 14 Hot Swap / Insert of 1G/10G Modules on OS6450
- 16 OmniSwitch Upgrade Overview
- 16 Prerequisites
- 16 OmniSwitch Upgrade Requirements
- 17 Upgrading to AOS Release 6.7.1.R01
- 17 Summary of Upgrade Steps
- 18 Upgrading - Step 1. FTP the 6.7.1.R01 Files to the Switch
- 19 Upgrading - Step 2. Upgrade Uboot/Miniboot and AOS
- 20 Upgrading - Step 3. Upgrade the CPLD
- 21 Verifying the Upgrade
- 21 Verifying the Software Upgrade
- 21 Verifying the U-Boot/Miniboot and CPLD Upgrade
- 22 Remove the CPLD and Uboot/Miniboot Upgrade Files
- 23 OmniSwitch Downgrade Overview
- 23 Prerequisites
- 23 OmniSwitch Downgrade Requirements
- 23 Summary of Downgrade Steps
- 24 Downgrading - Step 1. FTP the 6.6.5 Files to the Switch
- 24 Downgrading - Step 2. Downgrade the AOS
- 24 Verifying the Downgrade