amplifiers. Integra DTR-9.1
Add to My manuals92 Pages
The Integra DTR-9.1 is an AV Receiver that offers a wide range of features and capabilities. With its high-quality audio and video performance, the DTR-9.1 is perfect for enjoying music, movies, and other entertainment content. Some of the key features of the DTR-9.1 include:
- Support for Dolby Atmos and DTS:X surround sound
- 9.1-channel amplification
- Built-in Wi-Fi and Bluetooth for wireless streaming
- HDMI 2.0a connectivity with HDCP 2.2 support
- 4K Ultra HD video pass-through
- Phono input for connecting a turntable
- Zone 2 audio output
- OSD (On-Screen Display) for easy setup and control
advertisement
26
Connecting a graphic equalizer and power amplifiers
Connecting a graphic equalizer Connecting power amplifiers
The AMP IN and the PREOUT connectors are attached with jumper plugs. When connecting a graphic equalizer, remove these jumper plugs before connecting the audio connection cables.
1. Remove the jumper plugs.
2. Connect a graphic equalizer.
Notes:
• Keep the jumper plugs so that you will not lose them.
• When the connectors are not in use, replace the jumper plugs.
Using auxiliary power amplifiers allows you to listen at louder volumes than with the DTR-9.1 alone. If power amplifiers are used, connect each speaker to the corresponding power amplifier.
1. Remove the jumper plugs.
2. Connect the power amplifiers.
Notes:
• Keep the jumper plugs so that you will not lose them.
• When the connectors are not in use, replace the jumper plugs.
R L
Equalizer
C Sw
Surround back right speaker
Surround back left speaker
Surround right speaker
Surround left speaker
Front right speaker
Front left speaker
Center speaker
Subwoofer
Subwoofer
Power amplifier
Subwoofer
FRONT
SURR
SURR
BACK
R L
AMP
IN
C PRE OUT
1
SUB
WOOFER
2
FRONT
SURR
SURR
BACK
R L
AMP
IN
C PRE OUT
1
SUB
WOOFER
2
DTR-9.1
AM
ANT.
FM
ANT.
75
MULTI
CHANNEL
INPUT
TAPE
1
FRONT
SURR
SURR
BACK
R L
AMP
IN
C
R
PRE OUT
1
SUB
WOOFER
2
L
ZONE 2
VIDEO S VIDEO
1
MONITOR
OUT
2
OUT
RS 232
TAPE
2
C D
PHONO
R
GND
L
OUT
I N
I N
I N
OUT
I N
VIDEO
1
OUT
IN
R
OUT
VIDEO
2
IN
L
VIDEO
3
VIDEO
4
VIDEO
5
DVD
IN
IN
IN
VIDEO
IN
S VIDEO
1
2
3
AC-3
RF
DIGITAL
OUTPUT
(COAXIAL)
COMPONENT
VIDEO
Y
INPUT 1
PB PR
DIGITAL
INPUT
(COAXIAL)
BACK
L
4
5
BACK
R
DIGITAL
OUTPUT
(OPTICAL)
L
1
2
3
DIGITAL
INPUT
(OPTICAL)
R
SURROUND (SURR)
SPEAKERS
Y
INPUT 2
PB PR Y
INPUT 3
PB PR Y
OUTPUT
PB PR
AV RECEIVER
MODEL NO.
DTR-9.1
A
12 V TRIGGER
AC OUTLETS
L
FRONT
SPEAKERS
( 6 OHMS MIN. )
R
AC 120V 60Hz
SWITCHED
TOTAL 120W 1A MAX.
B
CENTER
SPEAKER
( 6 OHMS MIN. )
MAIN
IR IN
ZONE 2
AC
INLET
DTR-9.1
AM
ANT.
FM
ANT.
75
MULTI
CHANNEL
INPUT
FRONT
SURR
SURR
BACK
R L
AMP
IN
C
R
PRE OUT
1
SUB
WOOFER
2
L
ZONE 2
VIDEO S VIDEO
1
MONITOR
OUT
2
OUT
1
VIDEO
1
OUT
IN
2
3
TAPE
1
RS 232
TAPE
2
C D
PHONO
R
GND
L
OUT
I N
I N
I N
OUT
I N
R
OUT
VIDEO
2
IN
VIDEO
3
VIDEO
4
VIDEO
5
IN
IN
IN
L
DVD
VIDEO
IN
S VIDEO
4
5
1
2
3
AC-3
RF
DIGITAL
DIGITAL
INPUT
(COAXIAL)
BACK
L
BACK
R
DIGITAL
OUTPUT
(OPTICAL)
L
DIGITAL
INPUT
(OPTICAL)
R
COMPONENT
VIDEO
Y
INPUT 1
PB PR
SURROUND (SURR)
SPEAKERS
Y
INPUT 2
PB PR Y
INPUT 3
PB PR Y
OUTPUT
PB PR
AV RECEIVER
MODEL NO.
DTR-9.1
A
12 V TRIGGER
AC OUTLETS
L
FRONT
R
AC 120V 60Hz
SWITCHED
TOTAL 120W 1A MAX.
B
CENTER
SPEAKER
( 6 OHMS MIN. )
MAIN
IR IN
ZONE 2
AC
INLET
advertisement
Key Features
- Dolby Atmos and DTS:X surround sound support
- 9.1-channel amplification
- Built-in Wi-Fi and Bluetooth for wireless streaming
- HDMI 2.0a connectivity with HDCP 2.2 support
- 4K Ultra HD video pass-through
- Phono input for connecting a turntable
- Zone 2 audio output
- OSD (On-Screen Display) for easy setup and control
Related manuals
Frequently Answers and Questions
How many HDMI inputs does the DTR-9.1 have?
Does the DTR-9.1 support 4K Ultra HD video?
Can I connect a turntable to the DTR-9.1?
advertisement
Table of contents
- 2 Important Safeguards
- 3 Precautions
- 4 Contents
- 5 Supplied accessories
- 6 Features
- 7 Before using remote controller
- 7 Installing the remote controller batteries
- 7 Using the remote controller
- 8 Front panel facilities
- 9 Front panel
- 9 Front panel door
- 10 Front panel display
- 11 Remote controller
- 12 Rear panel facilities
- 16 Example of how to connect your equipment
- 17 Standard connections
- 18 Connecting your audio components
- 18 Connecting your video components
- 20 Connecting speakers
- 20 Ideal speaker configuration
- 20 surround sound playback
- 20 Speaker placement
- 21 Connecting speakers
- 21 Connecting the speaker cable
- 21 Connecting a subwoofer
- 22 Connecting antennas
- 22 Connecting the included antennas
- 22 Assembling the AM loop antenna
- 22 Connecting the AM antenna cable
- 23 Connecting an FM outdoor antenna
- 23 Connecting an AM outdoor antenna
- 23 Directional linkage
- 24 Connecting to the IR IN ZONE 2 input
- 24 Outline
- 24 Connecting the main and remote zones
- 25 Connecting to the IR IN MAIN input
- 25 Outline
- 26 amplifiers
- 26 Connecting a graphic equalizer
- 26 Connecting power amplifiers
- 27 Connecting the power
- 28 The On-Screen Display (OSD) menu
- 29 Navigating through the OSD menu
- 30 Speaker Setup
- 30 Speaker Setup menu
- 30 1-1. Speaker Config sub-menu
- 31 1-2. Speaker Distance sub-menu
- 32 1-3. Level Calibration sub-menu
- 33 1-4. Bass Peak Level sub-menu
- 33 1-5. LFE Level Setup sub-menu
- 34 Input Setup
- 34 Input Setup menu
- 34 2-1. Digital Setup sub-menu
- 36 2-2. Multichannel Setup sub-menu
- 36 2-3. Video Setup sub-menu
- 37 2-4. Listening Mode Preset sub-menu
- 38 Input source signals
- 38 Listening Modes
- 40 2-5. Delay sub-menu
- 40 2-6. Sound Effect sub-menu
- 41 2-7. Character Input sub-menu
- 41 2-8. Miscellaneous Setup
- 42 Listening Mode Setup
- 42 Listening Mode Setup menu
- 44 Description listening mode parameters
- 46 Preference
- 46 Preference menu
- 46 4-1. Volume Setup sub-menu
- 47 4-2. OSD Setup sub-menu
- 47 4-3. OSD Tweak
- 48 Zone2 OSD Setup
- 48 Zone2 OSD Setup menu
- 48 About
- 48 About menu
- 48 6-1. Lock Setup sub-menu
- 48 6-2. Version
- 49 Enjoying music or videos in the remote zone
- 49 Controlling the DTR-9.1 from the remote zone
- 49 controller
- 50 Listening to Radio Broadcasts
- 50 Listening to FM/AM Radio Stations
- 50 Tuning into a radio station
- 51 Presetting a radio station
- 51 Selecting a preset radio station
- 51 Erasing a preset radio station
- 52 Enjoying music or videos with the DTR
- 52 Selecting an input source
- 52 Adjusting the volume
- 52 Changing the listening mode
- 52 Listening with headphones
- 52 Using the many features of the DTR
- 53 If one of the messages shown below appears
- 53 Enjoying the multichannel output
- 54 Recording a source
- 54 currently watching or listening to
- 55 you are currently watching or listening to
- 55 the audio from another
- 56 Using remote controller
- 56 Overview
- 56 device
- 56 Controlling the DTR
- 58 Controlling an Integra CD player
- 58 Controlling an Integra MD recorder
- 59 Controlling an Integra cassette tape deck
- 59 Calling up a preset radio station
- 60 Controlling an Integra DVD player
- 60 SAT, CABLE, VCR, and TV MODE buttons
- 61 into the remote controller
- 61 Programming procedure
- 63 button
- 63 a MODE button
- 64 Using a Macro function
- 64 What is a Macro function?
- 64 Programming a Macro function
- 64 Running a Macro function
- 65 Programming the Direct Macro function
- 65 Running a Direct Macro function
- 66 Erasing a macro from the MODE MACRO button
- 66 DIRECT MACRO button
- 67 been programmed
- 68 Troubleshooting guide
- 68 POWER
- 68 SPEAKERS
- 69 FM/AM TUNER
- 69 VIDEO and AUDIO
- 69 REMOTE CONTROLLER
- 70 OTHER
- 71 The default settings
- 72 Your system setting
- 72 Inputs
- 74 Speakers
- 74 OSD Setup
- 74 About
- 75 Remote controller
- 76 Specifications