FM/AM TUNER. Integra DTR-9.1

Troubleshooting guide

FM/AM TUNER

AM stations cannot be received.

• AM loop antenna is not connected.

➞ Connect the included AM loop antenna to the

AM antenna terminals.

Buzzing noise on AM stations (particularly noticeable at night or with weak stations).

• Noise from electrical apparatus such as fluorescent lamp.

➞ Move the AM loop antenna to different position.

➞ Set up an outdoor AM antenna.

Noise is heard at high-pitched sounds on AM stations.

• Noise from TV set.

➞ Place the AM loop antenna as far as possible from the TV.

➞ Move unit away from TV set.

Crackling noise on both AM and FM stations

• Noise caused by fluorescent lamp being turned on and off.

➞ Move antenna as far as possible from the fluorescent lamp.

• Noise from automobile ignition.

➞ Install an FM outdoor antenna as far as possible from the road.

➞ Change the position or direction of the outdoor antenna.

The indicators light for stereo reception, but sound is distorted and stereo separation is bad.

• Station is too strong.

➞ Change to FM indoor antenna.

• Multiple reflection of the radio waves because of tall buildings or mountains.

➞ Use antenna that has better directivity and select a point where distortion is least.

Indicators for stereo reception flicker and hiss is heard on FM stations.

• Station is too weak.

➞ Install an outdoor FM antenna.

• Stereo FM broadcasts cover only about half the distance of an ordinary broadcast.

➞ Change the position or direction of the outdoor antenna.

No preset station is recalled.

• Power cord has been unplugged or the POWER switch has been turned off for a long time.

➞ The memory contents are lost. Store all stations again.

VIDEO and AUDIO

Desired picture does not appear.

• Improper connection.

➞ Check the connection again. Insert the plugs and connectors completely.

• Video Setup sub-menu of Input Setup menu settings are incorrect.

➞ Check Settings.

No on-screen display.

• Improper connection.

➞ Check connections.

• OSD Menu is only display to monitor connected to

MONITOR 1.

➞ If connected to MONITOR 2, reconnect to MONI-

TOR 1.

Picture and sound do not match.

• Improper connection.

➞ Check connections.

• Video Setup sub-menu of Input Setup menu settings are incorrect.

➞ Check settings.

No sound, or sound of the selected source is not heard.

• Digital Setup sub-menu of Input Setup menu settings are incorrect.

➞ Check settings.

No picture appears on the TV screen (or monitor).

• TV (or monitor) is not set to receive the output signals from the receiver.

➞ Set the TV (or monitor) to the receiver input.

• Video cable is not connected securely.

➞ Check connections.

• S VIDEO IN signal is output at VIDEO OUT and S-

VIDEO OUT, but VIDEO IN signal is only output at

VIDEO OUT. Also, COMPONENT VIDEO IN signal is only output at COMPONENT VIDEO OUT.

➞ Check the input and output signals.

REMOTE CONTROLLER

Front panel controls function but remote controller controls do not.

• No batteries in remote controller.

➞ Insert batteries.

• Batteries have worn out.

➞ Replace batteries.

69