- Computers & electronics
- Audio & home theatre
- Supplementary music equipment
- Panasonic
- WJ-NV300K/G
- Installation Guide
advertisement
24
Connection
Connection of cameras
Up to 32 cameras can be connected to the recorder via a switching hub.
Connect to the Camera/PC port of the recorder.
Use a LAN cable (straight) to connect the recorder and the switching hub.
Recorder
AC IN SIGNAL GND
HDD 2
VIDEO
OUT
AUDIO ALARM/
CONTROL
EXT STORAGE
2 1
HDD 1
10/100/1000BASE-T
PC CAMERA/PC
AV OUT
MAIN
VIDEO OUT
SUB
LAN cable (locally procured)
10BASE-T/100BASE-X/1000BASE-T: category 5e or better (straight) for
WJ-NV300K, category 7 (straight) for
WJ-NV300K/G
Switching hub
・・・
Network camera (x 32 max.)
Note:
• For the connection between the recorder and the camera, build the system so that the total bit rate of 128 Mbps is secured
• as the network bandwidth.
Make sure to use the wired network to connect with the recorder even for the cameras equipped with the wireless LAN function.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 4 Limitation of liability
- 4 Disclaimer of warranty
- 4 Warranty for U.S
- 5 Important safety instructions
- 7 Preface
- 7 Features
- 8 About the user manuals
- 9 System requirements for a PC
- 9 Trademarks and registered trademarks
- 10 Abbreviations
- 10 GPL/LGPL
- 10 Copyright
- 10 Network security
- 11 About the face matching function (option)
- 11 Notation about the installation and setup of the camera
- 14 Precautions
- 17 Precautions for installation
- 18 Major operating controls and their functions
- 18 Front view
- 20 Rear view
- 22 User/Host management
- 22 When operating from a PC via a network
- 23 Operations flow
- 24 Connection
- 24 Connection of cameras
- 25 Connection of monitors
- 26 Connection of a PC
- 28 Connection of extension units
- 29 About the connector
- 29 How to use the terminals of the ALARM/CONTROL connector
- 31 Time and polarities of the ALARM/CONTROL connector
- 32 Installation or replacement of the hard disk drives
- 32 Install the hard disk drives
- 33 Replace the hard disk drives
- 34 Turn on the recorder
- 34 Turn on the power of the recorder
- 35 Turn off the power of the recorder
- 36 Register the license (Registration Key)
- 38 Basic operations
- 40 Setup menu
- 41 Configure the minimum settings [Easy Start]
- 44 Troubleshooting
- 46 Specifications
- 47 Standard accessories