- Computers & electronics
- Audio & home theatre
- Supplementary music equipment
- Panasonic
- WJ-NV300K/G
- Installation Guide
advertisement
34
Turn on the recorder
Turn on the power of the recorder
Turn on the power of the recorder. When using the recorder for the first time, register the license for the recorder. (☞ Page 36)
Step 1
Connect the provided power cord to the power cord inlet on the rear panel of the recorder, and insert the power plug to an outlet whose rating is as follows.
WJ-NV300K: 120 V AC, 60 Hz
WJ-NV300K/G: 220 V - 240 V AC, 50 Hz/60 Hz
→ → The [OPERATE] indicator will light, the system check of the recorder and the hard disk drives will start, and the startup window will be displayed on the main monitor.
Step 2
If the "Registration Key" for the recorder has not been registered yet, register the "Registration Key" by following the procedures on page 36.
Note:
• When the "Login" window is displayed during operation after startup, enter the user name and password. Refer to the Operating Instructions (PDF) for descriptions of
• how to operate.
The default administrator name and password are as follows.
Administrator name : ADMIN
Password : 12345
• If the "Registration Key" for the recorder is once registered, the message asking you to register the
"Registration Key" will not be displayed from the next time.
Important:
• Never turn off the power of the recorder during startup.
Note:
• If the license for the recorder has not been registered yet, the message asking you to register the "Registration
Key" will be displayed.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 4 Limitation of liability
- 4 Disclaimer of warranty
- 4 Warranty for U.S
- 5 Important safety instructions
- 7 Preface
- 7 Features
- 8 About the user manuals
- 9 System requirements for a PC
- 9 Trademarks and registered trademarks
- 10 Abbreviations
- 10 GPL/LGPL
- 10 Copyright
- 10 Network security
- 11 About the face matching function (option)
- 11 Notation about the installation and setup of the camera
- 14 Precautions
- 17 Precautions for installation
- 18 Major operating controls and their functions
- 18 Front view
- 20 Rear view
- 22 User/Host management
- 22 When operating from a PC via a network
- 23 Operations flow
- 24 Connection
- 24 Connection of cameras
- 25 Connection of monitors
- 26 Connection of a PC
- 28 Connection of extension units
- 29 About the connector
- 29 How to use the terminals of the ALARM/CONTROL connector
- 31 Time and polarities of the ALARM/CONTROL connector
- 32 Installation or replacement of the hard disk drives
- 32 Install the hard disk drives
- 33 Replace the hard disk drives
- 34 Turn on the recorder
- 34 Turn on the power of the recorder
- 35 Turn off the power of the recorder
- 36 Register the license (Registration Key)
- 38 Basic operations
- 40 Setup menu
- 41 Configure the minimum settings [Easy Start]
- 44 Troubleshooting
- 46 Specifications
- 47 Standard accessories