Supervisory Connector. Lippert Cool FrontRunner PC/104-Plus
ಜಾಹಿರಾತು
ಜಾಹಿರಾತು
Technical Manual “Cool FrontRunner” Version 2.7 17.06.2008 Page 28 of 43
4.16 Supervisory Connector
Connector type: Hirose DF14 25-pin
Primary (Secondary, function available only on request)
Signal name Pin Signal name Pin
+5 Volts 1
GPIO0 3
GPIO2 (IDE) 5
GPIO4 (IrDA-Receive) 7
GPIO6 (100Mbit) 9
SUSPEND 11
PME# (SMI#) 13
USB2+ 15
USBGND 17
+3.3 Volts
GPIO1 4
GPIO3 (IrDA-Send)
GPIO5 (ACT)
GPIO7 (LINK)
LIVE
USB2VCC
2
6
8
10
12
14
USB2- 16
USB3+ 18
USB3- 19 USB3VCC
COM3-TX+ (SLP-BTN) 21 COM3-TX- (SYS-FAN) 22
COM3-RX+ (TACHO) 23 COM3-RX- (DIS-FAN) 24
GND 25
Note: The 3,3 volts are generated by an on-board DC-DC converter. It must be not used to supply power to any peripherals with high power consumption.
4.17 Display Type Selector
Connector type: IDC6 pin header 2.00 mm. Use 2 mm jumpers to choose the display type.
TFT: Jumpers between Pins 4&6 and Pins 1&3
CRT: Jumpers between Pins 4&6 and Pins 3&5
BIOS: Jumper between Pins 2&4
1 2
3 4
5 6
Default setting: BIOS select
When using BIOS for Display Selection enter Special CFR Features Setup in BIOS and select via
Display Type.
Note: The board must be turned off after saving and exiting setup, and then turned on again. Otherwise no setting changes will be made. If an error occurs and no image on the monitors can be seen, press “0 / INSERT” on the numerical keypad or
“INSERT” on the cursor block at boot time to load BIOS defaults. BIOS default is CRT display. After loading default values, the board must be turned off and on again, too, in order to make the changes correct.
ಡೌನ್ಲೋಡ್ ಮಾಡಿ
ಜಾಹಿರಾತು