Deactivating the water container indicator:. Electrolux EW6C5852CM, EW6C5752CM, EW6C5722CM, EW6C5822CM

7.2 Adjustment of remaining laundry moisture

Every time you enter in the

"Adjustment of remaining laundry moisture" mode, previously set degree of remaining moisture will change into next value ( e.g

previously set change into ).

will

To change the default degree of remaining moisture:

1. Press the on/off button to activate the appliance.

2. Use the programme knob to set any programme.

3. Wait approximately 8 seconds.

4. Press and hold buttons (E) and (D) at the same time.

One of these indicators comes on:

• the maximum dryness

• the more dry laundry

• the standard dry laundry

5. Press and hold buttons (E) and (D) again until the indicator of the correct level comes on.

If the display returns to the normal mode (the time of the selected programme from step 2.

will be displayed), while setting the degree of remaining moisture, press and hold buttons

(E) and (D) once again to enter to the

"Adjustment of remaining laundry moisture" mode

(previously set degree of remaining moisture will change into next value).

8. BEFORE FIRST USE

Rear drum packaging is removed automatically when dryer is activated for the first time. Possible to hear some noise.

ENGLISH 11

6. After 5 s the display returns to normal mode.

7.3 Water container indicator

By default, the water container indicator is on. It comes on when the programme is completed or when it is necessary to empty the water container.

If a draining kit is installed

(additional accessory), the appliance automatically drains the water from the water container. In this case we recommend that you deactivate the indicator of the water container.

Deactivating the water container indicator:

1. Press the on/off button to activate the appliance.

2. Wait approximately 8 seconds.

3. Press and hold touch buttons (B) and

(D) at the same time.

The display shows one of these 2 configurations:

• The display shows "Off". After 5 s the display returns to normal mode.

• The display shows "On". After 5 s the display returns to normal mode.

7.4 Buzzer on/off

To deactivate or activate the acoustic signals, press and hold for approximately

2 seconds touch buttons (A) and (B) at the same time.

Before you use the appliance for the first time:

• Clean the tumble dryer drum with a moist cloth.

• Start a 1 hour programme with moist laundry.