advertisement
USERS QUICK REFERENCE GUIDE
USING A VCR, OR OTHER VIDEO SOURCE
Use the Trackball Remote to Access Menus and Make Changes
Once the HD Display has been installed and set up, follow these simplified instructions for operation. Be sure to install batteries in the remote. See “Trackball Remote” section for further instructions regarding remote operation.
Note: If Video In is used without a connection to loop out, “Loop Out Switch” must be put to the “In Only” position.
VCR or other Video Source Setup Instructions
Connections VCR to Video In on HD Display
VCR Audio Out to Audio In of User Supplied Stereo System or
Menus
Audio Amplifier.
Source Menu -
Select Video as Video image source.
Setup Menu -
Select Aspect Ratio and select proper ratio.
Select Static Setup and adjust if necessary.
Format
Video Menu -
Make RGB Source adjustments if necessary.
If the new video source has not been connected before, it may be in a format not recognized by the HD Display. If the new format is not recognized, save it and give it a name.
Adjustments Make any additional image adjustments as required for this unique setup. See the “Installation and Setup
Guide for System Installer” for set up instructions.
Source Menu with Video selected as Input Source
P A G E 1 2
206-3275-A
advertisement
Related manuals
advertisement
Table of contents
- 2 SAFETY WARNINGS
- 4 IMPORTANT SAFETY INSTRUCTIONS
- 6 Installer’s Experience Level
- 6 Installation Considerations
- 6 National Power Cord Requirements U.S., Canada
- 7 Connections Center
- 7 Connections Options
- 7 Description/Function
- 8 Connecting Computer Video Sources
- 8 Connecting Video and S-Video Sources
- 9 Setup Checklist
- 9 Basic Operation: Projecting a Picture
- 10 Using a Computer as a Video Source
- 11 Communications Port Inter-Connection Wiring Reference
- 12 Using a VCR or other Video Source
- 13 Using an S-Video VCR or other S-Video Source
- 14 Introduction
- 14 Battery Installation
- 14 Programming Your Remote to Operate Other IR Devices
- 15 Basic Operations
- 17 Other Brand Equipment Programming Codes
- 18 Remote Key Functions in Other Operating Modes
- 19 Amplifier Volume Override
- 19 Cable Volume Override
- 20 Auto Find: Automatic Brand Code Search
- 20 Cleaning The Trackball
- 21 Available Menus
- 21 Features)
- 22 Trackball Menu
- 22 Status, Copy, Sleep Timer, Z-Trak, Store
- 22 Sleep Timer
- 22 Source/Time Display
- 23 Available Source Menu Options: Video, S-Video, RGB
- 23 Changing Input Source
- 23 Input Sources
- 24 Setup Menu Options
- 25 Clock Set
- 25 Timer Setup
- 25 On/Off Timer
- 25 Enable/Disable On/Off Timer
- 26 Language
- 26 Video Mode
- 26 Aspect Ratio (Picture Proportion)
- 27 Format Pref. (Preference)
- 27 Label Format
- 27 Blank Setup
- 28 Static Setup (Red, Blue, Green Convergence)
- 29 Adjustments
- 29 Video Menu Options
- 30 RGB Source Special Adjustments
- 31 Caring for Your HD Projection Display
- 31 Cabinet Care
- 31 Lens Cleaning
- 31 Extended Absence
- 31 Picture Interference
- 32 Before Calling For Service
- 32 Problem Identification Chart
- 32 RGB Source Problems
- 35 Notes