Additional speaker fall prevention measures. Panasonic SCHTB550EB, SCHTB550EG, SCHTB550GN

SC-HTB550_RQT9666-1B_mst.book Page 17 Monday, March 12, 2012 12:32 PM

Connect the speaker cables.

≥ Insert the wire fully, taking care not to insert beyond the wire insulation.

Back of the base



Insert the wire fully.

r

: White s

: Blue line

Push



Press into the groove.

≥ Place the speaker that is connected with the speaker cable with a red connector on the observers’ right, and connect with the speaker cable with a white connector on the observers’ left.

Additional speaker fall prevention measures

To prevent the speakers from falling, it is recommended, as an additional protection measure, to attach the speakers to the wall or table with a fall prevention cord (hereafter “cord”).

≥ Consultation with a qualified installation specialist concerning the appropriate procedure when attaching to a concrete wall or a surface that may not have strong enough support is recommended ( > 11, 13). Improper attachment may result in damage to the wall and speakers, and personal injury.

≥

Use a cord that is capable of supporting over 10 k g (with a diameter of about 1.5 mm).

≥

Keep the screws out of reach of children to prevent swallowing.

≥ Make sure that the slack of the cord is minimal.

When attaching the speakers to a wall

Horizontal placement













Vertical placement













A

Cord

§

B

Screw eye

C

Wall

D

Wall-mounted speakers

§ If the cord cannot be threaded through the holes, try bending the cord in 2 locations, about

10 mm apart from the tip, at an angle of 45 o

(as illustrated above).

RQT9666

17

SC-HTB550_RQT9666-1B_mst.book Page 18 Monday, March 12, 2012 12:32 PM

When placing the speakers on a table

Horizontal placement





Vertical placement









A

Cord

§

B

Screw eye

≥

Depending on the placement of the speakers, the screwing position of the screw eye may differ.

C

D

Wall

Approx. 150 mm

§ If the cord cannot be threaded through the holes, try bending the cord in 2 locations, about

10 mm apart from the tip, at an angle of 45 o

(as illustrated above).

18

RQT9666

