advertisement
For an explanation of the effect of this button when more than one image is selected, refer to Working with Multiple Selected Images .
Calibration (Light Source)
The light source is calibrated each time you turn on the scanner. However, you can also control the frequency of the light source calibration. Click this button, and on the dialog window that appears, indicate whether calibration should be performed before every frame scanned, or whether it should be performed once for each filmstrip. If it is performed once for each filmstrip, the calibration occurs when the first prescan is performed for that filmstrip.
When scanning slides, the calibration is performed before each scan.
About (Version Numbers and Firmware Upgrade)
Click this button to display scanner information (including the software and firmware version numbers), and an Upgrade button.
Click Upgrade to initiate a firmware upgrade; firmware is the software within the scanner. You begin this process by receiving a new version of the firmware, perhaps by downloading it from http://www.kodak.com
. Downloading places a file on your hard disk. When you run that file, the firmware is extracted and saved to the default location our your hard disk.
Then you use this button to copy that firmware file from your hard disk into the scanner. When you click the button, a dialog window appears allowing you to select the firmware file named 3600_nnn.bin, where nnn represents version number. For example, if nnn is 101, it indicates firmware version number 1.01. If you have followed the default installation procedure, that filename should appear in the dialog box; otherwise locate the firmware file in the location at which you saved it during initial software installation. Initiate the upgrade and the new firmware will be downloaded to your scanner; wait while the upgrade procedure is completed.
3 CAUTION: It is important that you wait and allow the upgrade to complete before performing any other computing activity. During the upgrade
60
advertisement