Using the Wine Opener. Brookstone APERTO

10

LOCATION OF PARTS AND CONTROLS

1. Wine Opener

2. Charging LED

3. Charging Base

4. DC Jack (rear)

5. Reset Hole

6. Foil Cutter

7. Reset Tool

8. Adapter

5 6

1

7

8

2

3

4

IMPORTANT - BEFORE FIRST USE

The WINE OPENER must be activated before first use.

1. Remove the FOIL CUTTER from the WINE OPENER.

2. Insert the provided RESET TOOL into the RESET HOLE.

The corkscrew will activate for several seconds.

3. Replace the FOIL CUTTER on the WINE OPENER. The

WINE OPENER is now ready for use.

11

12

CHARGING THE UNIT

1. Plug one end of the ADAPTER cord into the DC JACK on the CHARGING BASE and the other end into an outlet.

2. Place the WINE OPENER on the CHARGING BASE, ensuring that it’s firmly in position and fully engaged with the charging connectors. The CHARGING LED will illuminate while the unit is charging and will turn off when the unit is fully charged. It will take approximately 8 hours to charge.

3. The WINE OPENER will open approximately 60 bottles on a full charge.

IMPORTANT: The CHARGING LED must illuminate to ensure the unit is charging correctly.

USING THE FOIL CUTTER

Before using the WINE OPENER, remove any foil from the top of the bottle.

1. Remove the FOIL CUTTER from the WINE OPENER.

2. Place the FOIL CUTTER over the top of the wine bottle.

3. While gripping the FOIL CUTTER, push down and twist a half turn. Lift the FOIL CUTTER from the wine bottle.

4. Replace the FOIL CUTTER on the WINE OPENER.

13