Install Overlay and Classic Series Custom Panels. KitchenAid Bottom-Mount Built-In Refrigerator

C

A

IMPORTANT:

■

Install Overlay and Classic Series Custom Panels

Install the custom handles prior to installing the panels on the refrigerator. For more information on KitchenAid custom handle selection, refer to the KitchenAid Catalog, visit www.kitchenaid.com, or call 1-800-422-1230.

In Canada, visit www.KitchenAid.ca, or call

1-800-807-6777.

3. Slide the custom panels into the trims on the refrigerator door(s) and freezer drawer, making sure that the backer panel fits into the hinge side trims.

■

■

Create custom door overlay panels according to the specifications in the “Overlay Series Custom Panels” section.

KitchenAid is not responsible for the removal or addition of molding or decorative panels that would not allow access to the refrigerator for service.

Door Panel Installation

1. Remove all tape and door bracing from the refrigerator door(s) and freezer drawer.

2. Open the refrigerator door(s) and freezer drawer and remove the trims and corner caps on each door as shown.

A A

A A

B B

A. Panels

4. Reinstall the trims and corner caps.

5. Remove the protective skin from the screw covers. Snap the screw covers into the handle trim section.

A. Corner caps

B. Refrigerator door trims

C. Freezer drawer trim

A

Top Grille Panel

1. Grasp both ends of the top grille.

2. Push straight up; then pull straight out. Place the top grille panel-side down on a soft working surface.

B A B

A. Top grille

B. Cabinet side trims

24