Basic Connections. JVC HR-J4003UM

Add to My manuals
38 Pages

advertisement

Basic Connections. JVC HR-J4003UM | Manualzz

4

Basic

Connections

Antenna or Cable

Coaxial Cable

Flat Feeder

AC Power

Cord

Maching Transformer

Back of VCR

AC Outlet

TV

ANTENNA-IN

(Antenna or Cable input)

RF

OUT

RF Cable

(provided)

75 ohm terminal

300 ohm terminal

Back of VCR

RF OUT

CH3 CH4

INSTALLING YOUR NEW VCR

1

CHECK CONTENTS

Make sure the package contains all of the accessories listed in “SPECIFICATIONS” ( Z pg. 38).

SITUATE VCR

Place the VCR on a stable, horizontal surface.

2

3

CONNECT VCR TO TV

The connection method you use depends on the type of

TV you have.

RF Connection

● To Connect To A TV With NO AV Input Terminals . . .

a– Disconnect the TV antenna from the TV.

b– Connect the TV antenna cable to the ANT IN jack on the rear of the VCR.

c– Connect the supplied RF cable between the RF

OUT jack on the rear of the VCR and the TV’s antenna terminal.

AV Connection

● To Connect To A TV With AV Input Terminals . . .

a– Connect the antenna, VCR and TV as shown in the illustration.

b– Connect an Audio/Video Cable (not supplied) between the AUDIO OUT and VIDEO OUT jacks on the rear of the VCR and the AV IN jacks on the TV.

CONNECT VCR TO

POWER SOURCE

Connect the power plug to an AC outlet.

4

5

FINAL PREPARATION FOR

USE

Select the VCR channel (3 or 4) by setting the switch on the rear of the VCR as shown in the illustration.

Turn on the power to the TV. You are now able to perform simple playback ( Z pg. 10) and recording ( Z pg. 11).

NOTES:

The VCR channel is the channel on the TV which will display the audio and video signals from the VCR. The VCR's CH3-

CH4 switch sets the VCR channel to CH3 or CH4.

● The CH3–CH4 switch is preset to the CH3 position.

Set to CH4 if CH3 is used for broadcasting in your area.

● If your TV has no AV input terminals, set the channel on the

TV to correspond to the CH3–CH4 switch on the back of the

VCR.

Even if your TV has AV input terminals, you must connect it to the VCR using an RF cable in order to record one show while watching another (

● For full identification of the VCR's rear panel, refer to the

Index (REAR VIEW

Z

Z

pg. 21).

pg. 36).

advertisement

Related manuals