Drawing file
Drawing file
Topics
About the drawings in the drawing file, page 99
Bridge Control Unit outline dimensions, page 100
Camera Unit outline dimensions, page 102
About the drawings in the drawing file
Relevant drawings related to the installation and/or maintenance of the FX80 are provided for information purposes only.
Note
These drawings are for information and planning purposes only. Information may be omitted. Observe the source drawings for additional details.
The drawings are not to scale. Unless otherwise specified, all measurements are in millimetres. The original installation drawings are available in PDF and/or AutoCad's
DWG format. The original drawings can be downloaded from our website.
https://www.simrad.com
Some drawings and documents are not available from our website. These can be downloaded from the Simrad Dealer Club .
https://www.simrad.com/sdc
The installation shipyard must provide all necessary design and installation drawings, as well as the relevant work standards and mounting procedures.
If required, all documents provided by the shipyard for the physical installation of the
FX80 must be approved by the vessel’s national registry and corresponding maritime authority and/or classification society. Such approval must be obtained before the installation can begin. The shipowner and shipyard doing the installation are responsible for obtaining and paying for such approval.
977-00017011/1.0
99
Simrad FX80 Installation Manual
Bridge Control Unit outline dimensions
100
977-00017011/1.0
Drawing file
Related topics
Installing the Bridge Control Unit, page 37
977-00017011/1.0
101
Simrad FX80 Installation Manual
Camera Unit outline dimensions
102
977-00017011/1.0
