Adding engine oil. Wacker Neuson EZ36

Maintenance 7

Adding engine oil

B

1. Stop and park the vehicle. Stop the engine – see chapter “ Preparing lubrication” on page 7-9 .

2. Open the engine cover.

3. Wipe the area around the sealing push-in cap with a lint-free cloth.

A

Fig. 285

4. Open filler cap B .

5. Raise oil dipstick A slightly to allow any trapped air to escape.

6. Add engine oil.

7. Wait at least five minutes until all the oil has run into the oil sump.

8. Check the oil level.

9. Add oil if necessary and check the oil level again.

10.Close filler cap B .

11.Slide in oil dipstick A completely.

12.Close and lock the engine cover.

Environment

Use a suitable container to collect fluids and lubricants as they flow out and dispose of them in an environmentally friendly manner.

BA E16 en* 1.0 * E16_10_700.fm

7-35