Mount the Installation Brackets — Outside Mount. HunterDouglas Paramount Headrail Systems

INSTALLATION

Mount the Installation Brackets — Outside Mount

■ Mark 2" – 4" in from each jamb.

➤

If more than two “L” installation brackets came with your order, space additional bracket(s) evenly in 24" – 30" intervals between the end brackets and mark their location. Mount into wood whenever possible.

➤ Adjust mounting clips to allow 1 /

2

" clearance between the vane and the wall (i.e. 2 1 /

4

" for 3 1 /

2

" vane).

2 – 4"

30" Maximum

30" Maximum

2 – 4"

■ Drill the screw holes using a 3 ∕

32

" drill bit.

IMPORTANT: Use drywall anchors when mounting into drywall. Drywall anchors are not provided.

■ Attach the brackets using the screws provided.

■

Center headrail underneath mounting clips.

■ Tilt the headrail and insert it into the front edge of the mounting clip. Pull and roll the headrail up toward the rear of the blind and snap into place.

Paramount ® Headrail

Tilt and

Pull Forward

Rear

Tab

Roll Back

Push Up

PermaTrak ® and PermAlign ® Headrail

Tilt and

Pull Forward Rear

Tab

Roll Back

Push Up

9