Cord Adjustment — Cord and Chain Only. HunterDouglas Paramount Headrail Systems

INSTALLATION

Cord Adjustment

NOTE: Cord length and/or tension cannot be adjusted for PermaTilt ® Wand Control System. It is set in the factory to help ensure that the product meets cord safety standard.

To reduce cord length on a Side Draw Blind:

■ Open the blind.

■ Release the cord tensioner by removing the screws.

■ Locate the cord knot in the front of the lead carrier.

Cord Knot

Side Draw Carriers in the Open Position

■ Pull the cord to the desired length.

■

Tie a double knot.

■ Re-install the cord tensioner with the screws.

■ Test for proper cord tension.

■ Cut the excess cord.

To reduce cord length on Center Draw Blinds:

■ Release the cord tensioner by removing the screws.

■ Place the blind in the closed position.

■ Locate the cord ends in the front of the lead carrier.

■

Select the cord knot that adjusts the cord length only; if carrier movement is observed, select the other cord.

CAUTION: Cutting the wrong cord will cause irreparable damage.

■ Pull the cord to the desired length.

■ Tie a double knot.

■ Re-install the cord tensioner with the screws.

■

Test for proper cord tension.

■

Cut the excess cord.

Center Draw Carriers in the Closed Position

Cord Knot

12