Loading/Unloading A Memory Card. JVC GR-DF550US

MasterPage: Left

GR-DF550US.book Page 18 Thursday, February 24, 2005 11:17 AM

18

EN

GETTING STARTED

NOTES:

●

If you wait a few seconds and the cassette holder does not open, close the cassette holder cover and try again. If the cassette holder still does not open, turn the camcorder off then on again.

● If the tape does not load properly, open the cassette holder cover fully and remove the cassette. A few minutes later, insert it again.

● When the camcorder is suddenly moved from a cold place to a warm environment, wait a short time before opening the cassette holder cover.

Loading/Unloading A Memory

Card

Memory card (optional)

Clipped edge

Card Cover

(MEMORY CARD)

NOTES:

●

Some brands of memory cards are not compatible with this camcorder. Before purchasing a memory card, consult its manufacturer or dealer.

●

Before using a new memory card, it is necessary to format the card. ( 墌 pg. 35)

ATTENTION:

Do not insert or remove the memory card while the camcorder is turned on, as this may cause the memory card to be corrupted or cause the camcorder to become unable to recognize whether or not the card is installed.

Write/erase protection tab Label

1

Make sure the camcorder’s power is off.

2

Open the card cover (MEMORY CARD).

3

To load a memory card , firmly insert it with its clipped edge first.

To unload a memory card , push it once. After the memory card comes out of the camcorder, pull it out.

● Do not touch the terminal on the reverse side of the label.

4

Close the card cover.

To protect valuable files (available only for

SD Memory Card)

Slide the write/erase protection tab on the side of the memory card in the direction of “LOCK”.

This prevents the memory card from being recorded over. To record on this memory card, slide the tab back to the position opposite to

“LOCK” before loading it.